Hello. I really liked the video on the assembly and your model aircraft. But when I downloaded the details for printing, there was not enough detail. Please add wings and other missing parts to your model.
Hi, In this video, until you finish installing the electronics, the wing is not reinforced. When they show the decals it already seems reinforced! What do you recommend for it ???
I understand that you not recommend it, but in my case one of the parts was a little separated and so therefore I would like to reinforce it. I was thinking of using epoxi to fill and some mesh tape.
@@matiasdelellis2955 if that happened to you the most probable reasons are: lack of material during printing or not enough glue in the join. If you print and assemble correctly the wing the resistance is more than 15G. You can see an ultimate load test that we did (one of the first videos we uploaded)
Y cable is one option, if you have enough channels you can also connect each servo to one channel and use the mixer of your receiver to make them work simultaneously.
Recommended throw settings for the Model Z (starting around 10:30 in the video)
Elevator: Up 10mm, Down 6mm
Rudder: +/- 9mm
Ailerons: +/- 7mm
Félicitation,super boulot.
Hello. I really liked the video on the assembly and your model aircraft.
But when I downloaded the details for printing, there was not enough detail.
Please add wings and other missing parts to your model.
Hi. How much this plane costs in the end? Printing and buying the several components?
Hello. You can find the shopping list at www.eclipson-airplanes.com/
Hi,
In this video, until you finish installing the electronics, the wing is not reinforced. When they show the decals it already seems reinforced! What do you recommend for it ???
It is not necessary to reinforce the wing, it is already strong enough
I understand that you not recommend it, but in my case one of the parts was a little separated and so therefore I would like to reinforce it.
I was thinking of using epoxi to fill and some mesh tape.
@@matiasdelellis2955 if that happened to you the most probable reasons are: lack of material during printing or not enough glue in the join. If you print and assemble correctly the wing the resistance is more than 15G. You can see an ultimate load test that we did (one of the first videos we uploaded)
Im supposed to connect the aileron servos through a y cable?
Y cable is one option, if you have enough channels you can also connect each servo to one channel and use the mixer of your receiver to make them work simultaneously.
@@eclipsonairplanes ahh, yeah that makes sense. Thanks!
Noway to find the Center Of Gravity for this bird...