INSTALLING A FORGE RE-CIRCULATION VALVE TO THE ASTRA VXR
ฝัง
- เผยแพร่เมื่อ 26 ส.ค. 2024
- In this video, me and Brad install a Forge Re-Circulation Valve to the Astra VXR Nurburgring Edition.
Contact me: zacherygroom3@gmail.com
Like/Follow my Socials for updates/sneak peaks of what's to come:
Instagram: @that_jap_crapbox
Facebook Page:
/ zgvlogsofficial
TikTok: @zgvlogsofficial
----------------------------------------------------------------------------------------------------------------------------------------
UMR PLATES
Use code ZG15 for 15% off your order, free shipping and free sticky pads!
Instagram: @umrplates
Website: www.umr-accessories.co.uk
Go check them out!!
Undoing the vac lines just made the recirc valve you just installed void .it's the vac lines that open and close the valve as you release the throttle and the noise you hear is the air in the turbo hitting the blades and will eventually smash your core to bits. Leave it all hooked up as it's all attached to the boost selonoids and they control when the actuator opens which is why your not holding boost
Yea we only tried it, it's all hooked up properly again.
ive put a turbo smart recirc valve in ive replaced all vac lines and im still only holding 5 psi boost any idea on what else it could be??
Dont be daft mines been like that for over a year and my turbo is fine
Cut down an old 5mm Allen key it’s so much easier
Theres a O ring missing out of end of that turbo smart
Installed one of these on my kia proceed gt. Sounds epic
Would need proper bung/blank instead of just removing the vac line to make sure it weren’t leaking boost (which it was from your description at the end there) or a one way valve so that it would have pressure on the valve to keep it forced shut a bit better.
What spring did you put in it?
Put the yellow one in it whatever that does
@@ZGVlogs they have different strengths depending on what boost the car is running.
Good work but try doing this on a volvo s60r bloody nightmare
I'll never touch a Volvo again. Owned one and hated it 😂
@@ZGVlogs haha its a love hate relationship I admit
Hi, is it save to switch my standard recirc valve to the forge recirc without getting error codes/motor management light or limp mode? My car is original, not tuned (yet)
Just plug and play with the green spring?
Truthfully mate, not too sure as it isn't my car
Yes but don't use the stronger spring, there will be instructions to tell you how to set up
Video 3 of asking you to buy an LS400 and VIP it
No
Who is this muppet
should just blank it. quicker turbo spool! and the noise! people who say turbo life limited etc who gives a fuck enjoy it while you can!