วีดีโอ

Hi Calvin. I have the Yamaha Fj09 2016. Your videos have helped me understand it better. I don't know if it's already happened to you but mine is not marking the speed changes on the dashboard. Just turned it on, it marks all of them and after 10 minutes it does not mark 1 and 5 gears.

You the best men, thank you!!

my bike is uncomfortably vibrating at 5000rpms no matter what gear i switch into. what should i do/what is wrong?

Hey mate I followed this and done my own flush and change. Now I'm getting codes for sas and dsc tried everything callibration etc won't work any ideas ?

How long did it take you?

Useful video and would love to see the slipper clutch install or the repair on the rubber spacers with the loud clutch at idle/no tension. That fix is daunting.

That red E82 is sexy damn

Cool little video, thanks for sharing

Can you put the draggy in your pocket? I’m tryna figure out how to mount it on my zx6r!!

So i have an 09, it turns over and tries to catch but doesn’t catch. Think it’s the plugs?

Where i live we call it a 600 diversion.

I bend the pin almost every time I use one

Great video! Ive had mine for 14 years!

Thank you very much for your great video❤

I cringe at the phrase "loosen up the header bolts" It's been a few years since I put together my custom slipon with split pipe. But iirc the stock secondary cat can be drilled out for the same effect. My new mufflers flow freely enough that I get some mild post ignition on hard clutch decelerations and it happens at that cat. Could probably lean the fuel little enough in the stock settings to get it right. But it rarely happens on normal deceleration and the bike is a monster. That stock muffler is definitely a huge restriction. Makes the bike sound like a kazoo too!

Any understanding of what transmission he has whether it's the multitronic or tiptronic

I tried autozol with just towel and i love the shining bronze/ gold color of it!

That didn't look like a Dremel. Is there a full length video describing this process

I love your idea of weighing down the back end with containers full of water inside the top box. Beats my concrete block on the rack method.

Great video. I've just payed for a new battery and 2days after not using the bike I go to start it and it's dead.thanks for the tips.

Велкиа дяка Вам за Вашу роботу!

2024 09 and 09sp calls for 36 -41mm

Thanks :)) your videos are always super helpful

Hi can you help I’ve got fx6 s2 2008 dash display has gone off

Essa moto é maravilhosa, esse motor é muito robusto. Há relatos de motos circulando com +200 mil milhas sem nenhum problema no motor, apenas manutenção normal ❤❤❤ No Brazil é a Tracer 900 GT, tenho uma 2022 Cinza 🩶 Um abraço irmão!

What's the code for the quik shifter's sensor?

very nice video

Thank you so much for this video, i had no idea clutchless shifting was a thing. I was able to make it home.

Hi Calvin. My name is Des and I've been following you for some time as I was previous owner of FZ6 and now as I'm owner of 2019 Yamaha tracer 900. Do you have any video how to adjust front forks and rear shock absorber, but in most simplest way. I found that my front forks are bit too soft, so I would like to correct that without going to Yamaha dealership. Thanks for previous posts and keep up with good work.👌👍🏍

You da real MVP! Great video.

Screw everyone else this is the best installation guide on TH-cam for the install. Not one person mentioned what side the bottom piece with the hole should be facing/located !!! Except this guy. I had to do a lot of research and this is the only guy that mentioned that part !!!

Did the deal today and picking it up on Wednesday. 06 FZ6N, so no fairing and for that reason a bit uncomfortable at higher speeds or longer rides. Decent price and low milage. It has a few issues, front forks need servicing and so does the brakes. I thought I noticed a few misfires but I wrote it down to old fuel (it's been sitting for two years) or spark plugs. I hope it's not coils/cdi. It had one previous fault code, but none existing after either reset or battery reinstall. I'll follow your channel and make sure to ask you for advice when I would need a helping mind. :) Thanks for charing your thoughts and experience of the bike. /cheers

Any opinion on this version vs the previous model which was changed after 2003. ? About to potentially buy one so im curious. People telling me the previous model is better built, more reliable etc. What you think ?

the FI system and trans are also different

Cancer

This video will help me a lot. HAve to work on the chain for sure. Itś ratteling, so it will need replacement. I only need to recalculate the torque specs to metrics. And see if the chain brand and type is available in the Netherlands

I've seen car batteries run in the 13volts so tha tis not unusual.

Welding looks good, got to be careful no one does damage to themselves 😂

Hi there. I want to buy a Yamaha fz6. My only concern is that it has about 100k kilometres. Should I buy it or I should pass it?

Hi calvin, my fz6 would not able to enter co setting. D1 yes

Throttle body needs cleaned

Very Helpful. Thank you.

One thing I appreciate you mentioning is the ticking sound from the upgraded internals! I remember when I first did mine and I heard the ticking, I thought something was seriously wrong!

A Kawasaki 650 manual says to check chain tension from the tight spot. So its gonna have them.

is it canadian or will i have to pay international shipping

FYI it's 6.5L not 6.9L

Once again really useful for a novice like me👍🏼. Intend to adjust my chain tomorrow. Greetings and thanks from Denmark 🇩🇰😀

Awesome 😂

Which temp should radiator fan kicking in? Someone said at forums that not until 106°c but isnt this too high?

Also i forget whe you setp the carb on seca2 what was the piot scew pozition for the best result .i mean how many turns out.