วีดีโอ

Why didn't you drain the antifreeze from the engine block? There was a lot of dirty antifreeze left there.

Can you tell me if the instrument cluster trasparente clear plastic cover is removable?

Couldn't you just remove the pulley end near the door, not the motor end and then do this service? Why take the whole thing down?

Lame video, why not just show the permanent fix installing LMC5 kit, it’s 50 bucks? Would’ve only taken 5 more minutes.

Stupid question, but I'm completely new to this topic. I had a nasty surprise that my 2024 Toyota Corolla Cross hybrid didn't start on Xmas day, the battery was dead. Question: I park on the street. I don't have access to an electric plug. It looks as though this unit must be plugged in to work. Does there exist similar chargers that are stand alone, that I could recharge at home after use?

What is the best coolant to use for Lexus is250 2009?

I just finished doing the switch swap just as described here. The hardest part was to find the assembly, with switches installed, for my Samsung Model. It needs to be the correct assembly. I would not try to remove the switches themselves since all three might be on their last legs anyway, so why go through all this effort just to save a couple of bucks, and they can easily be damaged trying to get them out of the assembly. This video showed me the right way to fix this issue, and most microwaves are probably just like this one. Thanks for a helpful video!!!

Thanks for the location help. Great video

How has this Bando belt held up? I'm shopping around for brands.

Hi John, I was curious why you didn't drain the coolant from the engine block. Thanks.

Great video! Thank you. I have been wondering why my garage door has been getting noisier over the years and I found all my wear pads were gone. My opener is a belt drive and it is about 20 years old.

Thank you for your content you’ve been keeping my 03 Acura tl alive it’s got 260x miles.

So the trunk doesn’t open automatically? I think that’s what everyone is used to and expects. Will keep looking for the right ft-lb strength to achieve this effect

Nice job ..

I had been waiting to do my car until you posted this! Looks easy enough. Thanks!

The car is absolutely mint!

A Bando belt from RockAuto is $12...

Well done mate. Very comprehensive video. I want to pull out the IACV from my 1991 Subaru Liberty/Legacy(as iscalled in the USA). Watching your video gave me some helpful tips, e.g. how to block the coolant hoses but my main problem is finding a new IACV. Someone had one in the USA and it was over USD$500 plus shipping etc. I can't find one locally. I might find an old one at the wreckers. But an old one might not necessarily be a good one. I can't even buy a gasket for it. It's a big problem finding parts for old cars. It shouldn't be like that. I suppose I could pull it out clean it well and use the old gasket with silicone on the IACV surface and the surface on the other side. I'm sure that will make it the airtight. Silicones are a wonderful invention. I used silicone to join roof tiles that were broken in the middle. I even used silicone to repair roof tiles without even taking them off the roof. I'm surprised that your car has travelled over 614000 miles/988000km That's unbelievable. My 33 year old Subaru has only done over 310000 km/192000miles.

Video was super helpful! Thanks for this John!

Does anyone know where to buy one of these clips/ hooks that broke off in the video? My car is missing one...

Hi there! Great video...but a quick question - will the paperclip trick work on a 2012 is250? Thanks!

Does this explain the small and light ticking sound from behind the engine on my 03 tl type s?

Acura had literally no filters their or plastic tray

Is it normal in 12V AGM charging mode that when the green light has already flashed once, i.e. the full charge is about to end, the voltage drops again and the device flashes orange, i.e. is back at 75%? Or is this due to the charging curve, which registers that the battery is still weak and needs more charge to maintain the final voltage?

You over filled with oil. Acura states the capacity is 4.6qt with filter. You have just added 5qt. You are about half a quart high. The oil pump will fill up the filter within 2 seconds so pre-fill is unnecessary. I do like your video but please think about the amount of oil you use.

Hi I'm certain my truck lifts are gone, it does slam quite hard but can it also peal of the paint because that's what happening to my car

Thank you for showing the product and putting the products name in the description! Would've gotten the wrong one if it wasn't for your video so massively appreciated! Thank you!

My question is why remove that film? Did you have to remove it in order to get the mirror out

thank you so much, very helpful

Great video. Thank you.

brother how did you remove the 12 mm bold at 13:05!? i’ve been at that thing for days and it’s the only thing keeping. me from finishing the job. i’m right on the edge of stripping the screw and every how to video skips that part

That was a job well done and a great video. The only things I will probably do differently is use an infrared thermometer rather than jumping pins on the OBD port (It's usually only off by 2-3 degrees), and measure total fluid drained. You know you put 3 quarts in so you should get almost exactly 3 quarts out.

Do you really need to lift the car?

It's a self bleed system, the tube off the reservoir does the job.

180K miles on my 2000 TL down in FL. Just did the same job. Great video. Thanks! Tip: don't over tighten the hot lead...it's soft copper.

On average, how long do the Duralast coils last?

Do you want to date? Got a girlfriend?😍🥰😘

What a great video, I can't believe you managed to use your camera and we didn't miss a thing, thank you so much for making our life easier..

How do you get the window down if the motor is stuck in the up position ?

Can we jack it up on the differential with the block of wood?

This is the best video I've seen on this topic. Gave you a like so others can find it.

Does the car have to be hot cold or warm ?

Amazing video! And wow low miles on your car!

👍Great success 👍 lol loved the reference

Such a great video bro ❤❤

My belt at 18 years 108k miles. About to change. Condition looks okay as well. Thanks for the video.

Did I hear you say, “ Over 600,000 miles.”? Wow! How often do you change your timing belt? I changed mine at 120,000 miles. The new belt tensioner went bad about 25,000 miles into it. It was a lifetime warranty so they sent a whole new kit. So I did another full replacement bearings, idler pulley, belt and of course the belt tensioner ( didn’t replace the water pump again). I really enjoy your videos!

I have the same model. Did a full brake job. A few weeks ago. Your car is super clean and well- maintained like mine. Just an FYI… I did a lot of research before I did what I’m getting ready to describe. The transmission went out about 50,000 miles with the previous owner. As I’m sure you’re aware, there was a recall on the transmission. Dealer replaced it with a new one. I bought the car shortly thereafter. At about 70,000 miles I inspected the transmission fluid (old Honda mineral based) it was pretty dark. My local Honda dealer still had a case left.. they wanted around $20 a quart! I said no thanks. I ended up changing the fluid to the Valvoline multi-vehicle full synthetic. The procedure was .. drain 3 quarts and add 3 quarts..drive about 50 miles manually shifting through all of the gears. Repeat that process until you have pure red Valvoline ATF. The difference in shifting and quietness was astounding! It was like a different, better performance transmission! Now I do a drain 3 quarts and add 3 quarts every 3rd oil change. I have nearly 160,000 miles on it now. Still running great! No regrets! I just wanted to share that with you since I’ve been helped by watching your videos. Thanks again!

Nice job! I have to do my driver’s side and rear right passenger’s side. This video is very helpful!

Wish I would’ve found this video days ago