วีดีโอ

I won't be watching any more of your videos due to the foul language.

So....basically.........your video sucks!!

They bvs2 has the breathe catcher part ? You still like this better for fogging issues ?

My Honda EU2200i generator will run a 13,500 BTU Penguin a/c unit without a problem w/ 2-3 amps to spare without a SoftStart. Perfect. Ad a Parkworld 6-ft 12/3 extenstion chord is even better for $17.

Does it fit any tractor with SSQA

Where did you get that elink piece that your cardo charge cord plugs into? I take it that elink power cord goes on top of that piece on the back of your helmet. Thanks

I’d BASICALLY just plug into an ecoflow that has a built in 30amp plug 😂

Just wondering where I can get a couple of those Connexion E-linq communication system chargers for our oxygen helmets. I have looked all over the wb and cant seem to find them. Thanks

This is my opinion alone based on my experience with crossbows that shoot 400fps and up. I believe to make your crossbow setup more efficient, you should use arrows/bolts that are at least 50 grains heavier than the advertised speed. To make the arrows heavier just use a heavier broadhead. Adding point weight increases front of center and therefore increases accuracy. I shoot a 400fps crossbow and my custom arrows weigh 467 grains. I also use lighted nocks so that adds a little more weight. That's how I ended up with 467 grains and a speed of 367fps. Thanks for the video men.

If you have a tree near it it could have jumped

Lots of elk in Oklahoma haven succumbed to a 20 gauge slug.

Do you know what guage wire was prerun by crestliner? Finallly got a trolling motor ordered and want to make sure its installed properly.

Give a Lynx Rave RE 850 a go...will change your life.

Talks about how "Super" accurate it is but never shows any of his groups! 🙄

You are the only one I've found with much on this boat so will ask you lol. Your trolling motor....50" shaft?

We know its an awesome machine, what we want to know is what will break and what needs updating?

You cant run a 1900 watt Coleman Mach AC unit off that???

Just wondering where I can get a couple of those Connexion E-linq communication system chargers for our oxygen helmets. I have looked all over the wb and cant seem to find them. Thanks

58 grain !! Have you tried any other grains ? Which does the gun shoot best?

You've got that thing wrong you've got the windage turret on the top and the elevation turret on the side

Hows it holding up. I have a Mossberg 835 im looking to get a scope asap.

Soon to be a new RV'r can you list all the materials you used in this video so I know what I need to buy. I definitely want to set up my RV like this, thanks.

Think ranch fairy did a vid a couple weeks ago about the drop in speed w heavier setups. They lose less speed percentage wise than light bolts. Say for example a 100 grain might be 400 at 20 yards and 360 at 60 yards. For a 40 fps loss whereas a 150 grain would start at 380 fps at 20, but only drop to 350 fps or something..only losing 30 fps. So less speed loss because of momentum. Makes sense.. Im looking up vids cause im tempted to go to 150s w my r26..not sure yet

30k Canadian is out of my price range and I make 6 figures

How has the scope held up on the shotgun? Has the kickback caused it to loosen?

It’s a lot faster my friend

Baby

Have you tried to connect that soft starter to your Renogy 3000W inverter to run the A/C on the batteries? If so, how long did the batteries last and did the inverter handled the load?

How would this helmet do if doing more aggressive off trail riding, i wonder if it will get to warm causing lots of fogging issues? Thanks

@13:26, you essentially pointed out another good gripe as earlier in the video with the markings. They should provide some cable tips to protect the ends. With the amount of DIY today, why not? Its something like that which shows a company looking out for its customer base. Basically you should not have to use tape. Great vid.

POTTY MOUTH

Shooter should switch bows at 50 yards to see if the bow or the shooter is more accurate . . . just sayin'.

Great video! Those kneepads look sick!

What are the size of your batteries. Amp hour?

Clean install I will be doing this shortly with solar

Nice. Which WMU is this?

Also with the 310 the seat is removable so you can add a bidet. The 300 you cannot.

Why not use the passthrough function of the inverter to plug shore power into?

I’ve been trying to figure out how to hook up my inverter to the panel and was going back-and-forth whether or not I could just use an extension cord and your video help me make my decision. Thank you.

Good job 👍👏👌

There no difference in the rear suspension other than yours has the comp package better shocks and some bracing

Have you seen any interference with your jet and transducer? I have garmin stuff and they recommend not doing a transom mount with a jet motor and was wondering how it was working for you.

Just found your page......how come you put the trolling motor batteries there instead of in the back with the other battery? Was your gas tank custom or did you get it somewhere? Thanks for the great video, good chance I'm getting one of these boats in the near future.

You need to check at Ravin crossbow your string and your cables have stretched you've lost poundage and that's why the bowl is shooting slower then it should be

This essentially told us nothing

I grew and processed my own horse radish years ago (only once) and decided that it wasn’t worth the trouble. Your video shows just what you need to do, and frankly, it’s one of those homemade foods that I abandoned. I still remember the fumes coming out of my grinder. WOW!

Great useful attachment. You made it look easy. Enjoy your tractor.

I’ve measured the calibers of the projectiles themselves to be about 0.45 inches (11.43mm) in diameter from the shell before firing; sabot slugs are never the same bore diameter as the barrel itself; it’s why the round is packed in a sabot. Even if the slug were full-bore (shell crimping aside), 260 grains is incredibly light for something that’s supposed to have a wider bore diameter than .50 BMG. Great video otherwise, I’m just a nitpicky asshole (and also a fellow Savage 220 owner, although it’s yet to take a deer) is all.

Also.70mm cable like you're using can run 450a. 3000w/12v=250a. The 3000w invertor can hit 6000w peak.. hence a 300a = 3600w at 12v breaker is good!

The explanation turned yo7 British for a second "bloody solder"