วีดีโอ

nooice

I agree bad choice!

Awsome! Now my shit wont stain the bowl now!

Check out the full video for more details!

Those last few inches of dirt you covered the concrete with will start to rot your post

Thanks for sharing I have same problem on my basement door But I don’t have tools to sand it out a little piece so I used big knife and chopping little bit and now it works no more stuck.

calculator link is not allowing me to edit inputs. update the link please

This video is great not everyone has the best experience with professionals . I’m glad you posted this video

The price of these table tops seem to fluctuate quite a bit. I held out until Prime Day on Amazon and managed to nab one for under $60.

Very good video No No no sunscreen. We need the sun. They are wrong about sunscreen look at the poison in them

Mine low in the toilet it's self and won't flush the toilet paper

Where did that shirt come from I need one immediately lmao. Also very good video

thank you

Help!! My toilet water level is very low. I have the dirt fill valve and I’ve turned it all the way to the right so that there is more water in my bowl. After flushing however, the toilet bowl level is still very low. Help!!

Thanks Dad

I think you meant diameter not circumference

You don't need the braces when you dry pack, the concrete expands as it gets wet and holds the post strong. never had one move

Thanks!!

Check out the full video for more details!

Sir, what kind of mount should i buy if there is a beam on the wall?

I can spend hours edging in my garden

How do I do this if the top section of my window can't open?

DeWalt pack outs suck. They break. But don't worry they're coming out with a new setup that doesn't break It's only $1,000

So the "self-drilling" part means that I can just use a phillips tip to BEGIN a little hole, but I don't have to use a drill to go all the way in? Love the McDowell's shirt by the way

wall a bot is best to rent it rather bying it....

Yea it does leave very small holes similar to a nail. But if you look at the title it says big holes will not be made and that is correct.

So who else is doing this to sneak out?

Great info!

I just took down a door that is rubbing and checked the underside, pre finding this video. I wasn’t sure if it was the door or a toy. Sure enough it’s the door. My intent was to do something similar to what you’ve shown, however… my underside is shedding. It’s like the inside of the door is pushing out the bottom rim and is very very dry but fluffy substance. I shaved off a bunch anyway. I’m deciding if the door needs replaced or if I need to paint the underside to keep the insides in. Your door insides still look like plywood but smooth. Do you know what do do with dry smooshy bottoms? Is that a combo of heat expansion and water damage? Hugely possible in a household with kids.

Great review! Keep doing it...

How far do you have to end it to move left and right though? Can't tell but I think the third one might the right one but everything I find requires the the tv to be extended too far.

Very helpful and practical - thanks so much!

OR just put shims on lower hinge. WHERE to add the shims makes a huge difference. 1) on the bottom hinge, obviously 2) Door scrapes floor a) ...within first 45 degrees of opening swing i) shim between hinge and door b) ...beyond 45 degrees of opening swing ii) shim between hinge and jamb (framing that hinge is mounted to)

is an 8 inch hole big enough? sites are saying 12 inch hole, but that's a lot of concrete

Call local department/utility company before drill. You don't want to drill right into any underground pipe or electricity line.

What do you connect the red wire clamp to?

I’m a widow, live alone, so I have to do these little jobs myself. I didn’t know there were self drilling wall anchors. Thanks for the info.

Giraffe not garaffe. How could you possibly fuck that up

Check out the full video for more details!

What type of saw horses are you using?

Thank you for sharing. Liked and subscribed.

I don’t have water- just an ice maker. What can I do instead of running the water after installing the new filter? Should I just make ice and dump the first buckets?

Will the legs colapase and store at the full height or only at the lowest height

Great information!What kind and size of nails (brads?) and what kind of gun are you using?Please pardon if you've already answered this.thanks

3:26 - A nice idea for certain situations surely, but I'm not loving the gap it creates between the top and the next vertically oriented piece. Maybe change the backwards-turning joint to a downwards-turning one to preserve the straight up and down edge?

Wannabe Pro-tip: I like to dip my finger in rubbing alcohol before I run it over the caulk. It seems to smooth it out even better.

I gave you a thumbs up for locking the door and making me laugh 😆I just got done cussing my door out and needed that. Good info !

I have a Bora 4x6 and I plan to add a 2x4. I think they should have made the width a couple of inches narrower to better support a 4 foot wide sheet. I don't have the 4X8 but I suspect I would reach the same conclusion about its length as about its width. Although I consider that a design miss, overall I am very happy with the Centipede. For my money it offers many more positives than negatives.

How to order AB washer 😢

Check out the full video for more details!