วีดีโอ

The whole Damen car lmao I want to learn to fix mine 😅

Thank you for the video. I so appreciate your making a video and trying to be of help May I Strongly Add the following steps: - I used a screwdriver similar in size as in the video, to press at the lower portion of the button (Bad idea!!!) to get the button to pop up, as in the video. Afterwards, learned that the black button has 2 tabs underneath that presses outward (on the left & right side) in the middle. Thus, is essential to use 2 thin screwdrivers at the left & right side to press inward a bit. As a result of following directly the video, the two tabs broke inside the button. This means that the button won’t stay in the knob, and I must tape it down to keep it from ejecting off the handle continuously. now for the sake of getting bulbs to light the gears, now I have to replace the button if i can even find one for a 20 yrs old, 2004 Sonata. - The size of the socket is a 12 mm or I used a 1/2”.

Wow, great and simple. I saw a video that removes so much more. I think I can even do it myself

Can you put apple car play

You just saved me 100$ in labor

My pump works but, it doesn't spray much out of the passenger side.

I need one of those to buy. do you know of any

Perfect. Thank you.

Perfect, just what is needed!

Thank you, thank you! Mine just suddenly started falling out the backside (turns out the plastic AROUND the screws broke) and needed to just remove the unit until i can afford to get a replacement. I suppose puttinga new one on is just doing these steps in reverse?

Thx for this video🙏🙏🙏

Some bull shit how I have to replace the whole climate cover just to replace the center vents

This video was helpful. I just bought buttons for the lights. I had no idea why they weren’t working when I installed. I didn’t know that little clicky thing had to go in the hole. When I bought the car (used) years ago, my lights never had buttons. So last week I decided to order some.

Thank you

Very helpful!

It's a NUT!!!!!! LIKE YOU!!!!!!

I hope you don't call yourself a mechanic. And tell me you don't have a 12 mm deep well socket that you can use instead of twisting the shifter knob? When you pried off the black button of piece flew off. You cannot get those buttons at the dealership on Amazon or eBay I had to go to the junkyard and with my Dremel toll saw below the knob then I could take the piece but you broke it so you can't use it you just popped it on and made it look like you could use it. Is this how you work on all cars? Half ass?

Thank you so much ❤

Amazing. Thanks.

Thanks for the great video. I found taking the wheel off will make the job much easier , thanks again

Thank you for the time you put in to help folks. Clear and easy to follow. Great job

Another comment - be aware that when you remove the control assembly and the circuit board, you will probably find that the turn signals do not operate. So don't plan for a long downtime.

Be careful when prying out the larger assembly. Especially above the vents. Mine broke in the middle.

How does cruise work where is the fuse that runs the push button on dash located 8:35 ed

I have a 2005 Hyundai xg350L my cup holder cover won’t stay closed the clip is off .

Can't get it to open how can I open it

How in the hell did you do that with out cracking the dash padding? Miracle touch you have.

How do i remove and replace front bumper for a 02-03 Mitsubishi Galant.

Very helpful! Thank you!

You're trying to get loose the nut not the bolt

You should pull off the ruber gasket of the pump and put the gasket in the tank

Great video, except that petroleum jelly will erode the rubber seal.

Well I already had a replacement to install after pulling it out but I realized that the window controls on the new one don't work either, so I seem to have an issue with either the internal door wiring or the ECU itself

Nice. Thanks for this helpful video!

Bro take the belt off then the alternator then put the alternator back on then the belt done ...... u fight that belt tryna put the bolts in is hilarious 😂

Where did u get the splitter rods? I have a 2005

I Will praise you

Very helpful, but i think it is easier remove the o ring. Place it in the reservoir and then install the pump.

This is why I love the old Hondas. Super easy to take apart! Thanks for the quick video!!

Hi how do i remove the digital clock from it,please help

There is a screw in the ashtray that holds the lower bezel on. It would have been very helpful to know of its existence.

I know a lot about cars but I just did not know this, thank you

Thank you

Everyone is here after breaking theirs upon removal 😂 Me included

Thanks I broke the clips 🤣

Hello! A mechanic changed my cluster and put in another one and now my passenger airbag light is on! Help

How to get the mother board out

Thanks 👍...

Thanks for the help man.

Still helping 6 years later. 👍🏼