วีดีโอ

Exact same issue here currently. I don’t have the skills you so Joe. I’m not sure cheapest way to go about it. Jag dealership or a local garage do you think. Had the issue for 6 weeks now. Cars been wide open.

why do the house builder install these wrong and don't get picked up on in snagging!

Good video thanks. Just used it to do mine, wiper jets weren't working but could hear pump was working so took off that T piece and found that valve thingy had not really perished in mine but was curled up a little so I flipped it over and refitted and now my jets are working again 👍

Where do you get that type of schrader valve from? I'm in the UK...

I have a ground floor MegaFlo. Is it possible to perform the hot tap drain by running a pipe from a downstairs tap to a lower level? Is it better to install a drain-off tap somewhere adjacent to the Megaflo? Is the only solution to repeatedly call out an engineer (which I prefer not to for obvious reasons)? Or? Thanks if anyone can advise.

Establish the steps. Writer a script. Explain what you are doing and why. Find a quiet spot - no traffic or birds.

Thieving gits! I have the same car, 2010 version and the wiring harness is a bit longer. I wasn't able to obtain a new one straight away so I removed the old one, repaired the frayed cable that I found then replaced it and the whole thing took me about 20 minutes. I'm not a mechanic. I'm also not convinced the mechanism wouldn't work, maybe the same thing, a frayed cable in the harness? That's what the issue was with mine. If you try to apply power to it, it would probably work. The actual mechanisms are pretty bulletproof. I would be claiming some money back, the consultancy fee is absurd too. Jaguar dealers have a bad reputation for this sort of thing and I often wonder how many car sales it cost the company.

You couldve just bought an x3220 and boom done. its lga 775 too. no mod needed.

Its the blend doors not low freon

Try moving your hand out of the way.

This is heeeeeeeelaaaaaareous

No time in my life have I seen entire headlamp assemblies needing removal just for a bulb change. You sir, should have really asked around before embarking on this

Great video, thank you.

Duz it mater about the culler if not i have fixed it thanks

Helped me drain and refill my megaflo to get rid of a sulphur smell. Cheers!

I am unsure if some of you have tried this when you watch this but because we never use the boot keyhole, it sometimes sticks just at the point it releases the trunk. Your fingers might not have the strength so a pair of pliers to hold the key and turn it but if you feel you are putting too much pressure on the key then stop, I don't want you to break the key. The joy of the part that has gone is electrical so the key should work, its just the lock is seized a little and needs that extra tiny turn of the key.

Jaguar lost their market share just because of their greedy dealers !

How does charging work? How power is distributed between DC load and battery charging? For example if current is limited to 4A on buck converter and load consumes 3A. Will battery be charging at 1A or voltage drop will occur?

Hi Joe, did you consider removing the rear number plate and just drilling through the faulty Lock & using a screw driver to release the catch ?

is this a 5 gallon batch? Curious why you don't have the grain in earlier - getting some of the 'step inversion' at lower temps (even though most grains now are fine with 1 hour at 150f (sorry, don't know the centigrade conversion). I also thought the brewzilla had a sparge arm (though one would need to add water as you did) - maybe I confused it with a circulation arm during the boil?

Hi what was the size of the pizza? Regards

Aaravkulveer

Just saved me 2 hours of swearing and struggling to fond all the fixings.. Great job 👍

On the soft close mechanism, hidden behind a sponge like membrane inside a hole. Tear out the sponge and you will find a yellow torque receiver. Get a tool and turn it. The boot will open. Then the boot works fine, without the soft closing.... Thats a good thing. :)) So you definitely got ripped off on a few levels. Sorry man.

If I have turned off the isolation (blue lever) and the water isn't stopping, what do I need to do?

Avoid the Stealer!

Useful review thank you for taking the time to put it together

Hope you’re still enjoying some brewdays

This was very helpful, thank you

I have had the locking fault rectified, now after a few months the actual door handle doesn't open the door, seems like it's not pulling anything... Any suggestions?

Great video mate, but just for anybody else who wants to try this it can be done easily with the headlights in situ. Drivers side being easiest. Get your fingers on the securing clamp and twist it, the unit is easy then to get out with plenty of length on the cable, change the clamp over and put the bulb unit back in place and twist shut. NS remove air box and intake parts, loosen air con pipe bolt to give a little wiggle room, also lower plastic clamp. Repeat the light removal as the other side, little tighter but easy enough. Changed oth xenons to LED in 40mins

How well did the repair hold up?

my friend Eva, she had her Alternator / Battery both replaced then her key fob remote stopped working now the Jaguar XF refuses to open the Boot...we've tried everything before watching your vid...

Grazie per il video chiarissimo , volevo chiederti se sai il codice ricambio del cavo che si è danneggiato . Grazie

I have a megaflo and when I turn a hot tap on then off again, I get a loud vibration and juddering, like water hammer, coming from the tank pipework (hot water outlet pipe on the tank). If I open a tap lower in the system the noise stops, almost like dissipating pressure. Do you think this expansion air gap is the cause of this trouble? If not, what do you think is causing it?

From what you saw, woukd replacing just the motor be a viable option? Same specs, but better quality. The idea of buying a whole cheap replacement vs just replacing the electric motors.

Excellent thank you

Hello, I do not have any experience with TV repair, but my friend thge owner insists, he believes in me :-). It is always Samsung UE40C65410UP. Would you be so kind to put me on track with this problem? Where should I start checking first? what could that be? Is it dfixible? What are your thoughts? Here is the photo of the problem: drive.google.com/file/d/1e4keg4MtgY9_p-d6Dpp4dHHyM5o-1vup/view?usp=sharing

You do not need to remove the bumper in order to change the HID lightbulbs, I've just done mine, the front left one was a little bit tight, but it went fine.

Holy hell, those birds... I skipped this one.

Good .

Thankyou Joe, the information was gratefully received, so different to the previous years model. Spent over an hour at Halfords. They couldn't do it as it needed to touch the bumper, which they are not allowed to do.

Hi, can anyone help. Engineers installed the fibre cables in my street around 1-2 Years ago. 2 Days ago they said they are starting to build in my area but how long roughly would it take to go live?

Over 6.000 great reviews on this.genuine so I'm gonna buy. 110.00 not a lot of money.added bit of comfort.

Could this be the case if all 4 don’t rotate? Surely they’ve not all gone at the same time so I’m thinking it’s something bigger…

Your video is honestly no help. It's like f****** a child at a Doctor's office. Getting a thermometer put under their tongue be more detailed this fucking sucked

Thank for the video and have a look at your vlog. But could yoe, please, make the sound of the video some louder? My pc sound is on max but it is still barely intelligible.

Hello searching found

How did you get the middle seats out ? I saw the latches on the side bolsters . I cant gey the trunk open becaise the mechanical key is damaged as well.

Im trying tp remove my seats in my xf portfolio . My truck is not opening and the mechanical lock is damaged. Im trying to gain access to trunk from inside car . Is it possible to get the seat off from inside ? I have all the bolts removed bit the seats are latched at top . Any help would be great . I dony wanna break anything