![S/V Baby Adalynne](/img/default-banner.jpg)
- 33
- 91 473
S/V Baby Adalynne
เข้าร่วมเมื่อ 7 พ.ย. 2020
Sailing and repairs on my swing-keel 1973 Catalina 22.
She is a trailer-sailer.
Had a Catalina 25...some of the videos are about her. Also sailed on a Catalina 30 sometimes.
She is a trailer-sailer.
Had a Catalina 25...some of the videos are about her. Also sailed on a Catalina 30 sometimes.
Swing Keel Removal on Catalina 22
After a little trailer "docking" accident I wanted to check the Keel Hanger.
มุมมอง: 843
วีดีโอ
How to Build an Outboard Motor Stand with Test Tank
มุมมอง 1.6Kปีที่แล้ว
Had to do maintenance on my Mercury 2.5 hp outboard motor. This was the simplest way to make a stand and test tank. It only works with small engines. For a bigger engine add a plywood pad on both ends and screw though it sandwiching the garbage can for added strenght.
Atomic 4 Engine Gasket Replacement Catalina 30 Sailboat motor
มุมมอง 448ปีที่แล้ว
Having a bad exhaust leak we replaced the gaskets on the Atomic 4 Engine. Catalina 30
Sailing on a Quiet Day Catalina 25
มุมมอง 3Kปีที่แล้ว
Went out sailing...but it wasn't a wind day, however we just wanted to get away. This is an old video from a few years ago when I had my '75 Catalina 25
Sailing first time on a Catalina 30 in the Long Island Sound
มุมมอง 3.4K2 ปีที่แล้ว
Sailing first time on a Catalina 30 in the Long Island Sound
How to Step (Raise) the Catalina 22 Mast without a Ginpole easy
มุมมอง 14K2 ปีที่แล้ว
How to Step (Raise) the Catalina 22 Mast without a Ginpole easy
Climbing the mast of a Catalina 30 Sailboat with a block and tackle
มุมมอง 1.1K2 ปีที่แล้ว
Climbing the mast of a Catalina 30 Sailboat with a block and tackle
How to build a Sailboat Rudder for my Catalina 25
มุมมอง 4952 ปีที่แล้ว
How to build a Sailboat Rudder for my Catalina 25
Catalina 25 Sailboat Hull Scrub Underwater
มุมมอง 2922 ปีที่แล้ว
Catalina 25 Sailboat Hull Scrub Underwater
I bought a small sailboat Catalina 22 walkthrough
มุมมอง 1.6K2 ปีที่แล้ว
I bought a small sailboat Catalina 22 walkthrough
Quick Release Turnbuckle Install and Mast Stepping Raising Catalina 22
มุมมอง 2.8K2 ปีที่แล้ว
Quick Release Turnbuckle Install and Mast Stepping Raising Catalina 22
How to raise the mast on a Catalina 22 without a Ginpole
มุมมอง 9573 ปีที่แล้ว
How to raise the mast on a Catalina 22 without a Ginpole
Mast Raising with Two People Catalina 22 Sailing Stepping
มุมมอง 5713 ปีที่แล้ว
Mast Raising with Two People Catalina 22 Sailing Stepping
Mast Raising Stepping with Furling Quick Release Turnbuckles Catalina 22
มุมมอง 2K3 ปีที่แล้ว
Mast Raising Stepping with Furling Quick Release Turnbuckles Catalina 22
Portlight Removal and Gasket Replacement Catalina 22 25 27 30
มุมมอง 9K3 ปีที่แล้ว
Portlight Removal and Gasket Replacement Catalina 22 25 27 30
Beautiful! how many knots?
@@thegoodbyte probably hull speed… I think that’s around 6kts
That is a pretty girl out there cook,n. 🌬️⛵
I get nervous heeling mine this far lol, I tend to fall off before that.
Pretty skilled with that skill saw.😅😅😅😅
great video, I've been using my trailer winch with 2 people at this point, gonna give this a try next time. With the wind here it's a little difficult from keeping the mast from going side to side a little bit tweaking the mast plate. Maybe ill do some baby stays or something.
Love my Catalina 25. Such an easy boat to singlehand, especially with the tiller tamer which I see you have! Is this in central TX?
Lake Travis C25-s are great agreed
I needed this, thanks! Replacing smashed window on a ‘69 coronado 25
Very helpful, thanks!
many videos available. yours may be THE BEST.
Glad you like them!
Ope, just a boom. Man you made that look so pro. Good job!
Clear, concise, and simple. No further. research is needed for me..well done!
I have a 1974 Pearson which uses the same style portlights. Somewhere along the line I read something saying people with Pearsons were able to successfully use the Catalina resealing kits, and this is indeed the case. I have not come upon a video that covers all these steps as well as you have here. Catalina direct should reference customers to your video to accompany the one page instruction sheet they provide with the kit.
Funny…about a week ago I have sent Catalina Direct the video, which they watched and responded, but I am not sure if they going to refer this video…
That car jack is a great idea. My keel should really get reglassed, but what a lot of work. What year is your 22?
1973 It’s actually not that big of a deal to drop the keel. The wooden frame is the most important so the keel stays upright.
@@svbabyadalynne cool, mines 1973 too, tough boat. Enjoy : )
Same boat, i almost never lock the keel. Occasionally, if its knocking around during a rough overnight, ill lock it, for quiet sleeping but even that's rare. I struck bottom near a shallow beach once while it was locked . . . thought better after that and left it swinging free. No issues, love the boat, 1973 : )
I have to try this on my Compac 23. I’ve got some slapping wires inside the mast. Thanks!
I like it a drain on the bottom done stand w test tank
Any updates on this? That bolt with little bite good?
Yes it was fine and I have a second video when I removed the keel again a year plus later…
@@svbabyadalynne I just did my keel hangers without taking it off the trailer. I appreciate this video it helped alot. I just dropped the hitch to the ground put a saw horse under the back then jacked up the hitch. Made the room to replace the keel hangers and pin. Got lucky my pin is tight in the cast-iron keel
just wondering for the window sealant inside the basket. Apply a lot or just a little ?
Apply “little”, just enough so it doesn’t ooooze out, because the clean up is messy. The space between the gasket and the glass is very thin especially once it’s pressed back into the aluminum frame. Most important is that it’s a continuous bead of sealant when applied.
What do you paint fiberglass with? It looks great!
Bottomkote Interluxe
I just purchased and C-22. My boat does not have the halyards back to the cockpit. I was going to purchase the Catalina Direct Kit. Were the blocks you replaced for the halyards? If so, what brand and how do you like them now that you have sailed with them? I am wondering if I should just purchase quality blocks and such and not the kit. Your thoughts? Thank you.
Yes, they were for halyards. Those deck blocks were from Catalina Direct. They are fine. Unless you are planning to race, there is no point to buy expensive blocks or deck organizers. Make sure your halyards will clear the pop top when it’s open.
@@svbabyadalynne Thank You.
I like how simple your Keel Holder is. Did you design it or get plans from somewhere? I will need to drop mine and was wondering if I could get plans to build my own from you or if you could direct me?
Don’t drop the keel unless it’s necessary, just take a screenshot of mine and copy that design
Is the 4/1 pulley system a separate bit or rigging specific for raising and lowering the Mast? With that mechanical advantage, do you just use strength to hold the Mast as it is lowered or is there some sort of mechanical "locking/holding" going on? Does the end of the line from the 4/1 rigging just attach directly to the forestay?
Great job! Could you show a close-up, still image of the bow rigging you used to raise the Mast? Also, are the three forward stays disconnected when raising the Mast and just those three have the quick disconnects installed on them? I am trying to set my boat up/rig my boat correctly for single-handed Mast raising and lowering.
Without a Furling, is only the forestay disconnected when you go to raise the Mast?
Disconnect the Forestay and both Lower Forward Shrouds you need Quick Release Turnbuckles for those PVC tubes over the Port, Starboard and Lower Back Shrouds to keep the those turnbuckles upright so they don’t get entangled and bend Watch my other mast raising videos
i just got my 22. I have not raised the Mast. I do not have a Furling jib. Other than the forestay where else do I need the quick release as I will be raising and lowering my mast by myself and will need all the help (technology) I can get?
Disconnect Forestay Disconnect both Forward Lower Shrouds Get PVC tubes, slide them over both Shrouds port and Starboard and tubes over the Lower Back Shrouds The PVC tubes help the turnbuckles stay upright otherwise they might get caught and bend Watch my other mast raising videos: th-cam.com/video/_gAm4iEjAZU/w-d-xo.html
Here is the link: th-cam.com/video/_gAm4iEjAZU/w-d-xo.html
What year/Hull Number did the Pop Top become standard on the Catalina 22?
Honestly I don’t know. She is a 1973.
This was a huge PIA. Mostly just the part of trying to get a proper seal with the stripping around the glass on the corners...
Keel looks pretty good. Did you have to fair it up, or did it come that way? Or did it just stay that nice since it was cast
This is how it has been since I have bought her...Thx! BTW, thx for Your videos they are great!
Head tack clue luff leach foot Lol
@@fuznut7610 you must be so impressed with yourself.
Thank you!
Standard rig or tall rig?
Standard.
I didn’t see you put weather stripping back on the inside??
I did, but it wasn't necessary to put in the video...
Tank for info
thanks for the vid, very good information.... love the part "pain in the ass, thats what it is":)
Damn. I really hope I can take the keel out on my trailer...
That looks so peaceful and a lot of fun. I'll be taking the ASA 101 class in July, and I'm really looking forward to learning how to sail and getting out on the water.
Try to go earlier, so you can do more classes over the summer... ASA is very good.
@@svbabyadalynne That's not a bad idea, thanks.
I've passed by but never actually been to Lake Travis, is the drought still bad?
The Lake is 41 feet lower than "full". But still plenty to go sailing.
Is that 'The Flying Wasp II'? (Caddyshack joke) Happy New Year!
Happy New Year! Please explain...I am not getting it. LOL
How’s this thing holding up???
I had it for about a year...no problems. The sailboat was sold. The guy who bought it had her for two years. Did not complain about it...
washing machine
Blender too.
If you got a gas powered trolling motor
I just purchased my second sailboat, a much smaller Catalina 22. Thank you for sharing your experience with us. FYI: You may want to put your keep lock back in. When, not if, you keel your sailboat over, the keel will suck up inside the keel well and get stuck. The keel lock prevents this. Once you keel your boat over it will not self-rite and you will take on water eventually sinking your sailboat. Just a heads up, Catalina put that there for a reason, a big safety reason. Safe sailing, Grant
I am not sure how the keel would suck up into the keel well when keeling. You mean it would slide up? I never let my C22 to that extreme...that means the boat have to be perpendicular to the water...it would be uncontrollable. However you are correct if I would flip her over then the keel would slam shut. It is a long...ongoing discussion.
Such good l ine handling. I learned so much just from the first minute of video!
Nice work. I have a similar swing-keel boat and I never bolt it either.
Your too polite. I am sure they saw you and understood your intentions, They would have given some way to allow the turn. It is not like you can stop. Don't fret most sailors understand.
Simply the best
Thx!
Funny how I keep coming back to this video. The explanation is detailed, and the process is shown very clearly. I have a Catalina 25. I am going to try this method on my boat, but first with another person just in case. Thanks for putting this video on youtube.
Consider a 6:1 block and tackle, so your Mainsheet would not work... Make sure your mast crutch is stabilized. You might need a small gin-pole since your fleet angle will be super low. Sounds like a fun rig.
Nice
keep the videos coming
i'm in connecticut, if you ever want someone to go out and give a hand sailing with you...let me know.