Fixing Commercial Doors that Won't Close Properly (Hinge Bind) | Steel Door Institute
ฝัง
- เผยแพร่เมื่อ 5 ต.ค. 2024
- Is a steel door not closing correctly? This video shows how to fix when the hinge binds against the rabbet or the stop.
Find other door and frame installation and troubleshooting guides at:
www.steeldoor.o...
SDI member manufacturers offer high quality commercial steel doors and frames. View a gallery of their products at:
www.steeldoor.o...
*Note - Must use steel shims for fire rated openings.
Jump to:
00:24 Preparation
00:35 Fixing when the hinge binds against the rabbet
01:54 Fixing when the hinge binds against the stop
Be sure to use a #2 bit and strip out hinge screws
Lol.
Yah every single FUCKING time, I have an entire marriott property where the builders didn’t do any of our doors correctly and now they are terrible to replace or take off. Reinforcement plates missing or not welded onto frame
No other way to do it
Also, be sure when painting the door, to soak all the screw heads in with paint 🤦🏼♂
Just ran into this issue today too hinge is bent and 4 of the screws are rounder than the globe
Good stuff I wish guys would watch and learn this stuff.
The video is helpful! Thanks for sharing. If voice can be little bit lounder, it will be better.:)
Noted!
Really good thanks!!
So how would you go about repairing a steel door that won't close because it is hitting the top edge of the vertical frame but also hitting the horizontal part where the corner comes together?
Man. Wooden doors are so much easier to manipulate.
Nevermind. I just watched your video on twisted or out of square door frames.
I just had same issue. Here is the link for anyone else coming here later.
th-cam.com/video/d-DZgFFau50/w-d-xo.html
What if a corner is separated
We put in laminate floors in our automotive office that has steel doors how to we make it so bottom of doors don’t touch he floor three metal exterior doors
Crystal Clear Detailing Vlog if the entire door is dragging I would recommend you take these doors off and trim the bottom then reinstall!
⁸