I don’t understand this need for copper grease, all I can see happening to that copper grease you spray on the disk is it will go by centrifugal force flying off into the contact area of the disks and pads. 😮
Thank you for your comment. Unfortunately, we can’t recommend any installation method, a detailed manual can be found in the service documentation for the repair of your car. Best Regards, Autodoc team.
Je mets un pouce bleu mais le serrage des roues sur une C1 c'est 103 Nm, support d'étrier 88Nm, étrier 30 Nm, vis torx qui tient le disque 5 N.m. où trouvez-vous vos serrages ? 😟
There's a question over the 65NM Caliper torque setting . some believe it should be 90NM ?
and the Wheel nuts 100NM not 120NM ??
Very very nice video! No bullshit! :-)
I don’t understand this need for copper grease, all I can see happening to that copper grease you spray on the disk is it will go by centrifugal force flying off into the contact area of the disks and pads. 😮
A great video, thank you.
Wouldn’t you need to bleed the breaks after?
No not at all, you should check the fluid level is still correct but no need to bleed as no air will get in the system
The music is awful.
Please do these videos without music. Its so mutch more pleasent with only the tools noises. Cheeres
Good video anyway.
Thank you for your attention to our videos. We will make the necessary changes as soon as possible.
AUTODOC
Yes, please do without all that racket!
Good 👍👍👍
How to replace rear bumper of naza carnival 2010?? Help me out
Thank you for your comment.
Unfortunately, we can’t recommend any installation method, a detailed manual can be found in the service documentation for the repair of your car.
Best Regards,
Autodoc team.
Je mets un pouce bleu mais le serrage des roues sur une C1 c'est 103 Nm, support d'étrier 88Nm, étrier 30 Nm, vis torx qui tient le disque 5 N.m. où trouvez-vous vos serrages ? 😟