How to Change Mountain Bike Forks | Silent Shop

Eddie shares how he changes out a fork on a mountain bike. He replaces his Rockshox Yari with a Manitou Magnum Pro! He also demonstrates how to check static sag.
Gear ties used to hold up fork and caliper are Nite Ize Gear Ties: amzn.to/3jHlOjY
00:04 Secure fork to frame
00:08 Remove front wheel
00:12 Remove brake line from fork
00:14 Remove brake caliper
00:30 Remove bars and spacers
00:48 Remove fork and retain lower bearing
00:55 Remove top dust seal and retain top bearing
00:59 Clean bearing seats
01:03 Clean bearings
01:19 Install new crown race
01:30 Grease bearing seats and install bearings
01:51 Install new forks and secure to frame
01:57 Install spacers
02:01 Install bars
02:05 Mark where to cut head tube
02:16 Cut head tube (a little lower than mark - about .25 in lower)
02:29 File down burs and sharp edges
02:26 Install new star nut
02:48 Re-install forks, spacers, bar, and top cap - hand-tighten
03:06 Install wheel
03:14 Re-install brake caliper
03:54 Torque top-cap to spec and center bars
04:03 Evenly torque stem
04:15 Torque brake caliper and clean up zip ties
04:20 Check recommended pressure settings for rider weight
04:22 Inflate to recommended pressure
04:35 Prop rear wheel for balance and check static sag (static sag should be 20% of overall travel)
04:51 Add or remove pressure as necessary
05:00 Confirm sag is correct
05:17 RIDE!
This video was not sponsored by any of the brands mentioned in the video, all opinions are our own.
This video should be considered for entertainment purposes only, any action you take based on the content of this video is strictly "at your own risk".
#simplymountainbiking #SMB #mountainbiking