Foxboro SRD991 Smart Positioner Auto Calibration

Few simple steps start Auto calibration for Foxboro SRD991 Smart Positioner using Beamex MC2

[@mr.nizamulhoq851]

Dear sir,
have a good day.
i have recently facing problem in a a newly buying Siemens PS2 positioner connect with
existing Single acting linear actuator , 20mm stroke.during comissioning this
new control valve/actuator in initial condition its display shows P 85
and NOINI mode, at that time when i press + and - button the actuator
totally not move.only small sound hearing inside the positioner and some air
release backside of positioner , however pneumatic and electrical connection is
ok.if i place old existing positioner there then it easily move
the actuator after pressing + and - key in NOINI mode.
Moreover when i go in Log 5 ,NOINITM mode 30% open the valve in both
YEND1 and YEND2 once i press both + and - key.once i release button then
actuator go to zero @t doesn't hold at all.If its abnormal what can i do.would you please advice me.
if i press only either + or - button then actuator not move in YEND1 and YEND2
mode.but when i press both + and - button simultaneously then it open actuator
only 30% but not hold at all then when press hand button its display range
message.
will you please advice me its normal or abnormal?if abnormal then what can i do to fix this problem.
Really i am facing a horrible condition for this positioner at my site and i am apologetically wish to get you kind advice please.
Thanking You,
Engr.Nizamul hoq.
proprietor.
United Mechatronics Engineers.
Bangladesh.
Email: united.mechatronics@@t
Mobile : [phone] and
0088-01935675378(whatsapp)
Skype: nizamul.hoq1

[@celectricsdnbhd6690]

Hi sorry was just see you comment. Perhaps you should check the mounting of the positioner. As for rotary positioner there are directions need to follow when mounting. Pls confirm that

[@singhujk]

Autostart error 1 came what I do

[@alex485381]

Same problem, did you solve it?