You MUST bridge the connectors within ten seconds of inserting the key into the ignition, then you MUST press the hazard lights button six times within 10 seconds of bridging the connectors
I have made up a special obd2 plug with a switch on it to do this it looks a little bit more professional then putting a wire in the obd2 plug but does the same job and you can turn it off by the switch without unplugging it
Was trying on my 2008 didn't work... Any suggestions?? Was reading some forums on internet and says it works up to 2016 now my front doors won't lock nor unlock with the original key only the 2 back doors work
Buenas yo tengo una Lacer evo 8 se dejó de funcionar el control como lo podría programar x q ya lo isieron. De todo y nada o usted tendrá el diagrama es un evo 8 año 2003 lo agradezco gracias
You MUST bridge the connectors within ten seconds of inserting the key into the ignition, then you MUST press the hazard lights button six times within 10 seconds of bridging the connectors
Did you buy a car alarm together with the flip key? Or I can just buy a flip key instead?
I have made up a special obd2 plug with a switch on it to do this it looks a little bit more professional then putting a wire in the obd2 plug but does the same job and you can turn it off by the switch without unplugging it
sweeeet imma do this to my 05 😻💕
Where u get all the carbon fiber?
Hey how would I know if to get the 433mhz or 315mhz?
Can you do a video showing how to install the radio screen flat the deck
Hi brother. Does this procedure also apply to Mitsubishi airtrek 2006?
Was trying on my 2008 didn't work... Any suggestions?? Was reading some forums on internet and says it works up to 2016 now my front doors won't lock nor unlock with the original key only the 2 back doors work
I'm curious. Did you ever figure it out or do you break into your car every time you drive it?
Good job
Doesn’t work on my 2000 NM Pajero, any suggestion please.. cheers
what control model is it? or what frequency do you use? or any control works for you?
Buenas yo tengo una Lacer evo 8 se dejó de funcionar el control como lo podría programar x q ya lo isieron. De todo y nada o usted tendrá el diagrama es un evo 8 año 2003 lo agradezco gracias
after push alarm key 6 times, lock door of my car didn't get any action. Help !
Same as to my car, any suggestion?
Connect the wire from obd contact 1 to the ground of the cigarette lighter and everything will work out 👍
Can you make a video@@serobmanucharyan3554
Excelente
Where do you get that wire ? And what is it needed for
You bridge the gap between pin 1&4 of the OBD port to allow yourself access to the relearn function.
Paperclip or a piece of wire
i did this but it didnt work, changing the battery with a new one didnt work neither, so i need a new key fob.
how to program a new additional key, not fob ?
Thanks
please discrube the procedure to make clone/duplicate key for the same lancer 2005. as it have immobiliser function
Don't you need to turn the key in this procedure? Just leave the key in the ignition?
need to enter the key
Mine 2007 not working have any solution
Same here
How about on 2007 model?
Paano po manual scan ang cedia matic 2003 pahelp nmn po di kc mabasa ng scanner 2 na ginamit n scanner
I'm trying to do it on an evo 8 but it doesn't do anything
Didn't work on 2006 Lancer ES. 😔
Medida de tu reproductor xfa
Mitsubishi l200 2009??
Its not work (2004)
Good
👍