2011 Ford Galaxy Front Parking Light Removal

Vehicle: 2011 Ford Galaxy UK model.
In this video I’m showing how to remove the front parking light holder to replace any blown bulbs.
You have to remove the entire parking/fog light unit to replace it. The easy way of doing it is pulling it out front the front. Some have done removing the mud cover under the engine and then removing more brackets to get access to the bulb holder - this is a lengthy and difficult task to do!
1st step: go underneath the front bumper and using 8 mm socket, remove the screw through the 1st hole (only 1 screw to be removed). This screw holds the light unit in place.
2nd step: using a butter knife and slide it through the top gap, push the light unit down to release the catch inside, as shown in the video. The sliding place is roughly 50 mm from the edge.
Final step: using a plastic pry tool, pull the unit down and outwards, as shown in the video. Now you should have got the unit completely out ??
My one wasn’t blown but the water had damaged the wire. So I had to replace the entire wire with a new one.
Apologies for the miss framed video and I hope this help you lot to certain level.
Cheers

[@bozsokitamas468]

Tomorrow I will try to follow the steps and replace the bulb... Thanks for the video!

[@Liveyourlifewithafatcigar]

Thanks for the video,I have only gone as far as taking the nuts from underneath & then I couldn't figure out what else I needed to do.Will change my bulbs now when the weather is a bit more kinder.

[@peyta101]

😅ukukki I don’t know my😮😮

[@HarleyDavidson69]

Thanks for the video mate !!!

[@krabauke]

Cheers

[@nigelpurcell-herbert7260]

Well, useful but not quite that simple. There are 2 bolts holding the light in place from underneath and, although there are holes in the splash guard they don’t line up and you have to take the splash guard off to see what you are doing. Then you have to get the splash guard back on… good luck with that.

[@MrZakmuh]

This was done in a 2011 model. So please check variation on models. Cheers

[@kreso00007]

thank you !

[@stian87]

What kind og bulb is it ?

[@steveothehulk]

thats terrible design the need to remove the whole unit to replace a bulb

[@bozsokitamas468]

You need to remove the whole unit also to replace the headlight bulb! 🤦