How did you torque the bottom nut on the taper pin? Or did you just tighten it with a wrench to what you thought to be 60 ft-lbs? Since there isn't enough space to get a torque wrench and socket on the lower one?
Before you installed the bearing, you said it has something in the new one to prevent the movement but after you installed it, it had the movement? curious cause i just got a new bearing from mazzula and it doesnt move
@@OXCFilms okay thanks. I just got my new one from mazzula and the inner one where the uniball taper goes doesn't seem to wanna move. did you have this issue?
@@OXCFilms the arms I bought came disassembled. The uni ball wasn’t in the control arm and it won’t just slide in and I don’t really have access to a press or don’t even know if they’re supposed to be pressed in
How did you torque the bottom nut on the taper pin? Or did you just tighten it with a wrench to what you thought to be 60 ft-lbs? Since there isn't enough space to get a torque wrench and socket on the lower one?
Yea we just got it as tight as we thought would be good. No space for a torque wrench
Before you installed the bearing, you said it has something in the new one to prevent the movement but after you installed it, it had the movement? curious cause i just got a new bearing from mazzula and it doesnt move
It wasnt the clunking movement. The new bearing eliminated that
okay fair. i just got a new one sent to me and the inner bearing where the uniball taper goes is stiff. yours like that?@@OXCFilms
@@OXCFilms okay thanks. I just got my new one from mazzula and the inner one where the uniball taper goes doesn't seem to wanna move. did you have this issue?
@user-kt2xf9fb7i you should be good. Its a tight fit on that
Where did you buy the replacement uni ball?
We got the parts from mazulla
why does everyone fit these without any dust / water protection?
It does have the little cap
@@OXCFilms nothing meaningful
Did you have to press the new uniball in ?? You left out the most important part 😭
No it just slides in
@@OXCFilms the arms I bought came disassembled. The uni ball wasn’t in the control arm and it won’t just slide in and I don’t really have access to a press or don’t even know if they’re supposed to be pressed in
@diegocortez9935 did you contact mazzulla?
Uses crescent wrench as a hammer, what a Hack!
I’m tripping on the fact the uniball just tapped outta the uca… ain’t happening that easy with my total chaos..
How long did that uniball last?
Do you not use the cap to cover it or it fell off?
It last for about 2 years or so. Yes cap was on
Where did you buy the replacement uni ball?
On the mazzulla website. or you can also email him