Hallo sir, thank you very much for you video, it was quite ilustrative. I have a question, why did you filter it at 10 Hz, has it any purpose or it was just to show the behavior of the filter itself? Thank you
Hi there! Nice video! Just asking because I've been trying to do the same thing as you, but my output is in a sinusoidal waveform. When I tried to bend the strain gauge, no changes is recorded as well. Appreciate your kind response to my comment. Thank you :)
Hallo sir, thank you very much for you video, it was quite ilustrative. I have a question, why did you filter it at 10 Hz, has it any purpose or it was just to show the behavior of the filter itself? Thank you
Hi there! Nice video! Just asking because I've been trying to do the same thing as you, but my output is in a sinusoidal waveform. When I tried to bend the strain gauge, no changes is recorded as well. Appreciate your kind response to my comment. Thank you :)
You need to check in LabVIEW configuration there has many types of strain gauge bridge (quarter, half or full bridge circuit)
Hi, there.
I have the next problem Error 20023... "The following conditions must be met: 0 < f_low
i dont used Arduino uno thank you, sorry
Hay help me, device tab in daq seting missing at my labview my daq usb 6211 my labview 19
yusvari harza irawan you need to install Daqmx (update Oct 2019)
@@NitikornResearchPartner my daqmax 19.5 no update aviable on chek update or form ni web. what usb daq are you use?