⚡SOLIDWORKS TUTORIAL #34 || Design of Epicyclic / Planetary gear drive with motion analysis.

[@Browhat333]

This was very helpful. Thank you! Good pace, easy to follow. Made it myself along with the video and it worked perfectly.

[@lijojohn3901]

Nice presentation

[@ericwang-gf1sw]

thanks my hero

[@rishabhkumartiwari7992]

can you provide the specifications and why did u choose them?

[@matthewarns4990]

Thanks man

[@ssaysay-wn6in]

why is it when i upload a gear from the tool box the gear is very very very small, even at the largest module it is still very small

[@Maggio97]

I have a question, if I have a shaft within the bore of the gears how do I use the gear mate to select the inside of the shaft ?

[@77Avadon77]

Can you power a planetary from one of the planet gears instead of the sun gear?

[@bharatcanil3171]

Is it possible to make planetary spur gear with h diameter 36cm ?

[@Doofenshmirtz1088]

When getting spur gear from toolbox, solidworks error appears. It says "Failed to get writeable document"

[@joshuaongera8713]

make sure you are in an assembly and not a part

[@abhisheksarath3972]

When i did the last as u did my ring gear is also rotating

[@user-darkhan]

You can fix it and then again calculate your motion stady...

[@ishan777x]

@@user-darkhan thats not working. The assembly gets stuck

[@abhisheksarath3972]

When i gave 100 rpm the gear set is vibrating

[@bharatcanil3171]

Bro, is it possible to make a internal gear from tool box of 36cm diameter

[@axelcruzcanahuire8330]

me too, i changed it to helical gears and problem solved