When adding lubricants to air tools you do so to the air inlet not to some obscure screw on the body of the tool,unless otherwise instructed to do so. That slotted screw is used for calabrian of the tool and will affect the performance of said tool.
I'm looking for a tool EXACTLY like this. Informative video. My application is a little different though. I need to punch holes in 3/4 and 1 inch opening sheet metal brackets. What's the distance from bottom of flange to hole punch insert? I've tried to find spec, but I can't. Thanks again for the video.
At 3 minutes, I thought you’d be warning about hydraulic pressure air tools. Definitely important to set pressures. Finding the actual hose end pressure is worthwhile. 🇦🇺🤜🏼🤛🏼☮️🍀
I’m just saying, could you create this style flange in 14 gauge, and then use the two pieces of 14 gauge in a 10Ton hydraulic press to press 18 gauge cold rolled steel? 🇦🇺🤜🏼🤛🏼☮️😊🍀
![ปฏิเสธไม่ไหว (Crush on you) - LIPTA feat. No One Else [Official MV]](http://i.ytimg.com/vi/NBw1jF342vw/mqdefault.jpg)
That hole punch/bender is cool, also did not know that light had an awesome "special" feature.
that's a nice bit of kit there Dave . Bill @SolarGarage is a top guy
When adding lubricants to air tools you do so to the air inlet not to some obscure screw on the body of the tool,unless otherwise instructed to do so. That slotted screw is used for calabrian of the tool and will affect the performance of said tool.
I always put oil down the air inlet, but thanks for pointing that out.
What if the hole needs to be in the center of the material?
I bought that same Onyx one on Amazon, to replace a friends one on that I broke 😒. Works very well!
Interesting !
I'm looking for a tool EXACTLY like this. Informative video. My application is a little different though. I need to punch holes in 3/4 and 1 inch opening sheet metal brackets.
What's the distance from bottom of flange to hole punch insert? I've tried to find spec, but I can't. Thanks again for the video.
That is a pretty cool air tool. And it didn't even make your compressor kick on.
Yeah, it doesn't use a lot of air, just a lot of compression.
At 3 minutes, I thought you’d be warning about hydraulic pressure air tools.
Definitely important to set pressures.
Finding the actual hose end pressure is worthwhile. 🇦🇺🤜🏼🤛🏼☮️🍀
I’m just saying, could you create this style flange in 14 gauge, and then use the two pieces of 14 gauge in a 10Ton hydraulic press to press 18 gauge cold rolled steel?
🇦🇺🤜🏼🤛🏼☮️😊🍀
cool
That makes today Wankel Wednesday !