Setting up the V350 Pro - One Day At A Time with Dave from AgTeachering

[@adrimawardi9210]

Where I can buy a PCB Lincoln V 350 volt??

[@justinthomassen592]

I realize this is an old video, so I am HOPING the Original Poster/teacher still has this account and is active... BUT, does anyone know what the switch Above the (+) Terminal does? (or the two buttons off of the side?)
I am trying to figure out if this Welder is capable of welding DCEN AND DCEP, I just bought one but am still trying to learn the machine and cannot find any information in the user manual relating The swapping of electrode positive to or from Electrode Negative. I am trying to run special Flux core wire (For stainless steel) and it need's DCEP in order to work correctly. Do i just swap the (-) and (+) terminals?

[@iant419]

Here is the manual, just remove the space in the URL
www.lincolnelectric .com/assets/servicenavigator-public/lincoln3/im679.pdf

[@jordanlerma4887]

I have one how is the sound mine works but it has a very high noise like the fans are louds

[@jordanlerma4887]

So the wired for the ground you dont use a clamp ?

[@midwestfab6313]

In this application the unit is stationary. This allows for the work lead to be attached directly to the booth. The entirety of the booth is connected to the work table. Less clutter and less chances for a student to knock the clamp off and turn on the help light.

[@antoniow1825]

One piece of advice students, don’t swap leads under power. Cut the machine before doing it, it’s just good practice

[@shibocat8021]

Lolol, thanks for the video

[@iinnomko9840]

Жаль что ты не русский