Scout II Voltage Regulator Replacement for Original Gauges

Easy to install - NO soldering, MUST BE GROUNDED!
If your gauges are reading incorrectly or not at all, you may need this brand new high capacity solid state regulator kit. It replaces the old mechanical one behind your Oil/Temp gauge. NO MOVING PARTS! This regulator has a capacity far beyond the original and will not burn out under these loads. It will probably outlast you and your Scout. Ready to ship NOW! Directions included. Installation is a snap, tighten one nut and two screws and you are done.
If you are installing this yourself, only do so with a full gas tank. Test the brown wire before installing. It should output 5 volts. If it is outputting more that 5.1 volts. Do not continue and contact a professional.
Do not operate without a good ground. If operated without a good ground it could damage your other gauges.
Product #18124, find it here at Scoutparts.com

[@williamsalazar2536]

Where would you ground this to?

[@Ptbocam]

I second this where do we ground it?

[@stevebeals5663]

Ground the regulator to any screw on the dash. I have used the screw that secures the gauge to the dash board assembly.
@@Ptbocam