Hey, Awesome Flight! If i look at your thumbnail the it seems that you are using the MKS HV9767 Servos right?. I am building my Raw 500 at the moment and iam also using the MKS HV9767. It seems that the MKS Servos are a bit offset, i mean the likage from the servo to the swashplate is not very aligned. Did you use any spacers? was there any problem when programming your FBL or in flight? It seems that the MKS Servos are not a perfect fit for the Goblin RAW 500 (only position wise). I had them in my old Goblin 500 there everything was straight and 90 deg. angle when centered. thx. !
@@dueksnk7270 ok thank you! I also did that, servo horns are 90 degrees and rotorhead radius arms are also 90 dgrees but when everything is centered when i look from the tail side of the helicopter to the elevater servo (hope thats right) then the push rod is about 5 degrees off angle, but i think thats ok if all three servo pushrods are all the same. Its just unusual to me somehow. I have the V Bar Touch an a Neo V1 where you can trim the center position of the swashplate "and" the top and bottom end positions (level) so that should be no problem. If you had no problem to setup your RAW 500 with these servos (wich are awesome servos by the way) then there should be no problems, i will see when i make the setup in the V Bar.
nice
Hey, Awesome Flight! If i look at your thumbnail the it seems that you are using the MKS HV9767 Servos right?. I am building my Raw 500 at the moment and iam also using the MKS HV9767. It seems that the MKS Servos are a bit offset, i mean the likage from the servo to the swashplate is not very aligned. Did you use any spacers? was there any problem when programming your FBL or in flight? It seems that the MKS Servos are not a perfect fit for the Goblin RAW 500 (only position wise). I had them in my old Goblin 500 there everything was straight and 90 deg. angle when centered. thx. !
I cut the prastic ball links about 2-3mm each (both aileron) to make the servo arms 90 deg. also no spacer needed
@@dueksnk7270 ok thank you! I also did that, servo horns are 90 degrees and rotorhead radius arms are also 90 dgrees but when everything is centered when i look from the tail side of the helicopter to the elevater servo (hope thats right) then the push rod is about 5 degrees off angle, but i think thats ok if all three servo pushrods are all the same. Its just unusual to me somehow. I have the V Bar Touch an a Neo V1 where you can trim the center position of the swashplate "and" the top and bottom end positions (level) so that should be no problem. If you had no problem to setup your RAW 500 with these servos (wich are awesome servos by the way) then there should be no problems, i will see when i make the setup in the V Bar.