One down side of lifting a CR-V with suspension lift spacers is axle would bind and rip the boot. Thinking of dropping the motor for better axle angle. Instagram CR-V - / n9tmar
Try extended ball joints, I threw them on my lifted crv and have had no problem with the axles clicking yet. I have 2” spacers up front on mine..... helps the geometry a little
Just lifted my crv today. Got new a axle while I was at it but after the Install and the 1.5 inch front Spacer lift, it's leaking transmission fluid. It looks like there is about 1/8th of an inch gap where the axle goes into the tranny. Does this happen to you guys also. If not, what axle do you guys use?
I just put 2 inch spacers on my 1999 CRV and I have been through two sets of brand new CV axles from O’Reillys. They vibrate and Pop really bad. I have the 3° ball joints as well. Any help?
I don't know if it's the best idea to put honda bond where the camshaft seal is at. Your not suppose to but I guess you can do whatever. It's your car. But I watch all your video bro. Keep it up
If u forget to take off the axle nut while the wheel is on u can just shove a screw driver in the rotor
Vegas Dale I should of done that but didn’t think about it at that time.
Try extended ball joints, I threw them on my lifted crv and have had no problem with the axles clicking yet. I have 2” spacers up front on mine..... helps the geometry a little
Travis McGreck What brand of extended ball joint you used?
Just lifted my crv today. Got new a axle while I was at it but after the Install and the 1.5 inch front Spacer lift, it's leaking transmission fluid. It looks like there is about 1/8th of an inch gap where the axle goes into the tranny. Does this happen to you guys also. If not, what axle do you guys use?
Sher Vue is it leaking from passenger side?
I just put 2 inch spacers on my 1999 CRV and I have been through two sets of brand new CV axles from O’Reillys. They vibrate and Pop really bad. I have the 3° ball joints as well. Any help?
DogONRedRocket so you have 2” lift spacers in the front?
I don't know if it's the best idea to put honda bond where the camshaft seal is at. Your not suppose to but I guess you can do whatever. It's your car. But I watch all your video bro. Keep it up
Hey bro wats the brand of your bull bar?
It came off a Tacoma don't know what brand