Oasis Spa - How to Use Your Spa Tech Controller

www.oasisspas.com.au
Setting up the control system
Now you can turn your spa on at the power point or isolation switch
The spa will show the word “priming” on the control panel until the pipes are full of water then it will automatically start heating the water to the factory set temperature. It will also begin filtering the water based on the recommended daily times.
Now set the time and adjust the temperature if required.
The time can be set by pushing the up button until the screen shows TIME. Push the Ok button and the hours, minutes, date and other information can be set using up and down buttons to select the correct information and Ok to lock in that selection
To set the temperature, select the STMP option on the main menu or just push and hold the up or down buttons on the right hand side of the screen until the numbers change.
There are other non essential settings and features which can be managed through the main menu, which is shown by pressing the up or down buttons. Once you have chosen a feature to change, push the OK button and then modify the settings using the up and down buttons
to select and OK button to confirm
These features and how to modify them are explained in detail in your manual and on the DVD supplied in your spa warranty kit.
Turning on the jets and bubbles and lights
On the SV2 control panel, the first button is control your filtration pump. It can run in Auto, On and Off mode. You can manually turn it on for extra filtration but it will always revert to auto mode even if you turn it off
The second button is for your jet pump which runs all the water jets. It is attached to the second filter and can be used for maximum extra filtration when required. The next button turns the air bubbles on. You can adjust the strength of the bubbles using the up and down buttons or push the button twice to choose ramping mode where the bubbles cycle from high to low.
Moved to here - previously before last paragraph If you turn any pumps or bubbles on they will always turn themselves back off after 30 minutes.
The last button turns your light on and off.
The colour and effects of your lighting can be adjusted by the up and down buttons, pushing the OK button to confirm your selections
And if you want an extra filtration and sanitation boost after you leave the spa press the sanitise button
The SV3 control panel is almost the same but there is another button to control your second or third jet pump.
With these spas, some of the jets will be powered by the first pump and others will be powered by the second and third pumps The air bubbles work the same as with the SV2 This controller has three buttons to control the lights
1 to turn your lights on and off. One to select modes - using the up and down buttons to make your selection. And another to choose colours and intensity
If you wish to invert the display on this control panel, push the invert button, and use the sanitise button after a spa for extra filtration and sanitation
The SV4 control panel works like the SV3 control panel but there are 4 pump buttons. Three pump spas use the first button for the filtration pump and three for the jet pumps and 4 pump spas have no separate button for the filtration pump.

[@marylaurepittier1575]

Peux t on avoir la traduction en francais. Merci