Emko 4430 high limit config

This is the instruction set to setup an EMKO 4430 as a high limit controller.

[@profrefaey]

i have EMKO 9450 model - how can i do a factory reset for all saved parameter?

[@pikeas1540]

Hello good day
Is it possible to gradually adjust the temperature and time on this device? (For example, 1 hour at 500C, 4 hours at 800C, 1 hour at 1000C). If yes, how many levels can be done?

[@Naeemkhan-lb6ez]

Hi i would like to use my emko 9930 process controller as speed meter with 24 v dc supply is coming out from the motor drive.

[@nicholaslees6707]

You cannot directly do that without some mechanical means or electronic feedback loop that I give you a feedback.

[@Alsifer12]

Hello.I would like to have the regulator's instructions in Russian. We want to cooperate and purchase a large batch of similar thermoregulators

[@eslamfahmy4436]

hi i connect pressure sensor 20 m ampere and can't break sbr error can you help me ?

[@nicholaslees6707]

Sbr error is no sensor detected. Either your controller doesn’t support 4-20mA sensors or it’s not configured correctly in the in-t parameter for sensor type.

[@fdemir87]

Hello do you have user guide/manual
Best Regards

[@roryw4297]

Anyone make a walk-through for ezm 4430?

[@naushadhussain8053]

Please give some ideas when I want change value it not changing any value so how to change value

[@nicholaslees6707]

EMKO used have the capability to be password protected. You will need to check if it's locked.

[@dodop5]

@@nicholaslees6707 How to unlock?

[@naushadhussain8053]

Is there possible to reset the password and activate again if forget password

[@DerbederkralKemo]

Merhaba bu termostat Türkçe olarak anlatabilir misiniz tesekurler

[@nicholaslees6707]

Unfortunately I natively do not speak Turkish.

[@trikimohammed6532]

How can i change ctyp on of to PID

[@Vortomech]

You got PCnf and the cycle the variable to ctyp. Then press A/M to change it to PID.

[@trikimohammed6532]

I cannot change the only available setting is onof