🙌🏻🙌🏻 they’re not as unreliable as people say! Mines been an absolute gem. Even tho all of my videos make it seem like it’s got lots of down time, I just don’t post the good times far enough
@@GHSTII pritty cool. I got Manley Rod's and Manley I beam's. Also HKS 272 Cam's Haven't been able to run it tho. Was sent the wrong studs now I have to fix the block cuz I was sent 11mm instead of 12mm bolts. Pain in the rear. Gonna get it done tho. Block is bored .20 over so I feel bad. Would of liked to run away this summer. Went Acl bearings. All ARP studs. Going to call her vemon when she run's. 97 convertible
I could definitely run it richer, but I had it running pretty solid before the trigger swap idling at 14.7, as have others I’ve seen with similar setups. 13.8 would probably be a solid target, so I went in between and chose 14.2 to get it dialed in.
🙌🏻🙌🏻 they’re not as unreliable as people say! Mines been an absolute gem. Even tho all of my videos make it seem like it’s got lots of down time, I just don’t post the good times far enough
It’s a great platform to get out of it what you put into it!
Same I have a few and no major problems at all. I go back and forth between a 4g64 spyder and a 4g63 gst.
Do you have stock internals?
Nope. Fully built.
@@GHSTII what brand?
@@kainc7136 Eagle rods, Wiseco pistons, King XP Series bearings, etc. Also running an Evo crankshaft and HKS 272 cams.
@@GHSTII pritty cool. I got Manley Rod's and Manley I beam's. Also HKS 272 Cam's Haven't been able to run it tho. Was sent the wrong studs now I have to fix the block cuz I was sent 11mm instead of 12mm bolts. Pain in the rear. Gonna get it done tho. Block is bored .20 over so I feel bad. Would of liked to run away this summer. Went Acl bearings. All ARP studs. Going to call her vemon when she run's. 97 convertible
That’s pretty neat. It’s always something with these cars 😂 I hope you get it up and running to your liking!
isn't 14-1 ratio a bit lean?
I could definitely run it richer, but I had it running pretty solid before the trigger swap idling at 14.7, as have others I’ve seen with similar setups. 13.8 would probably be a solid target, so I went in between and chose 14.2 to get it dialed in.