Design of Thin-Walled Vessel -Tagalog Tutorial

In this video, you will learn how to design the thickness of a thin walled vessel or a cylindrical steel tank. It shows a step by step procedures starting from analyzing maximum pressure acting on interior surface up to calculation of steel shell thickness.

[@watchtvecs8037]

Thank you so much sir.....

[@robertinfante6358]

Thank you sir for sharing your knowledge and expertise. Tanong ko lang... Necessary po ba na magkaroon ng top at bottom ring beams or supports doon sa interface between dome and vertical shells?
If necessary, kinddly share din kung paano idesign ito. Maraming salamat.

[@sethanaduazo4414]

Practically, the term Dome shape head is not used in actual practice, we used Hemispherical Head and 2:1 Semi Elliptical Head (as per ASME / UL-142 Standards) pressure vessels and Horizontal Tank. for above Ground Oil Storage Tank, it is normally dome type calculated from 1.2D (as per API 650 /620). in calculation, we always considered mean diameter or mean radius. another important aspect.. the term Tank is applied for below atmospheric pressure while Pressure Vessel is above atmospheric pressure (Different principle and thickness formulas used in ASME and API Standard and not the same).

[@johndavegacul5565]

Sir baka pwede concrete formworks system naman kung paano ang analysis at design. Sana mapansin thanks

[@reynaldosira5770]

Up

[@erosguevarra6284]

Sir may part 2 pa po ito?

[@erosguevarra6284]

Sir may part 2 pa po ito?

[@jsdesign_engineeringtv3633]

Yes marami pa series yan thanks

[@erosguevarra6284]

Sir bakit po kyo nag assume ng 1m na differential strip? Para saan po yun?

[@jsdesign_engineeringtv3633]

@@erosguevarra6284 to simplify calculation instead of using the full height. Thanks

[@erosguevarra6284]

May question pa po ako. Anung reference niyo po sa pagkuha ng yield strength and reduction factor? Anung material po ang ginamit niyo? Thank you po sa pag savot

[@erosguevarra6284]

Sir yung reduction factor po ba same lang po yun sa poisson ‘s ratio? Thank you po