@duesenberger the Pup connectors dont fit the holes so i had to remove the connectors and feed em thro the hole then re-insert the wires to the connectors. 😁
@SAREL1963 i can't say because there are a lot of factors to consider like the wood used, craftmanship, other hardware, etc. For me, it is alright with my SG. Hope that helps
I replaced the original humbuckers in a Epiphone SG G-310 with these "Probuckers". I regret it and will be swapping back or just going with Gibson parts. The "Probuckers" are muddy and the splitting them did not sound very good either. Very difficult to find any decent tone. Worst thing I've every done to a guitar.
Just finished installing this setup in a Harley Benton sc-500, huge improvement, awesome!
Good to hear @bigfoot. More sound to choose from. 😁
Did the adapters of toggle switch and pickups fit through the routing holes for the wiring harness.
@duesenberger the Pup connectors dont fit the holes so i had to remove the connectors and feed em thro the hole then re-insert the wires to the connectors. 😁
Are they good enough to put in a Chipson les Paul.I bought one and sound horrible😢😢
@SAREL1963 i can't say because there are a lot of factors to consider like the wood used, craftmanship, other hardware, etc. For me, it is alright with my SG. Hope that helps
Bravo...😊😊😊
Show !!! Congratulations and thank'you very much!!!
How i disconnect the plastic connector from the selector switch? The connetor is different from the P-up one's
When you install the new quick connect wiring harness do you still have to solder the old ground wire to the new wiring harness?
Yes. I soldered that ground wire in the video to 1 of the tone pot. 17:00 time
A cual potenciómetro de tono lo soldó?
How do you tell which one was the neck and which one was the bridge
The one with a thicker mounting ring should be the bridge pickup and the other one should be the neck. 😊
I replaced the original humbuckers in a Epiphone SG G-310 with these "Probuckers". I regret it and will be swapping back or just going with Gibson parts. The "Probuckers" are muddy and the splitting them did not sound very good either. Very difficult to find any decent tone. Worst thing I've every done to a guitar.
I see. This may not always be the solution so, Yes, go for Gibson parts. Surely, that should sound with quality mate. Cheers 🍻😁🙏