Hi Jeremy I plan on using this set up when mine arrives in a week or so , to get the correct compensation on the elevator trim between wings extended and wings swept would it be a good guide to initially set her up with the integrated gyro and measure the elevator compensation given by the onboard gyro as a guide line ? Superb tutorial by the way 👌
No probs I did a 4th flight mode on my flaps and assigned it to the wing sweep which allowed me to put in elevator compensation and timed it to adjust at the same speed as the wings sweeping 👍
Thats quite a bunch of wires. I think i had plenty of them in my Freewing ME-262 - the cable management was not very good on the 262 - kinda a pain to assemble. This B1B looks amazing.
Excited to get it in the air soon!
Great explanation Jeremy, think I may go this route 👊🏼👊🏼
19:41 just add a delay to your mixing swept to elevator
Hi Jeremy I plan on using this set up when mine arrives in a week or so , to get the correct compensation on the elevator trim between wings extended and wings swept would it be a good guide to initially set her up with the integrated gyro and measure the elevator compensation given by the onboard gyro as a guide line ? Superb tutorial by the way 👌
Also where abouts on the gyro do you set your gain I was thinking 10 o'clock to start off with bud 👍
No probs I did a 4th flight mode on my flaps and assigned it to the wing sweep which allowed me to put in elevator compensation and timed it to adjust at the same speed as the wings sweeping 👍
Thats quite a bunch of wires. I think i had plenty of them in my Freewing ME-262 - the cable management was not very good on the 262 - kinda a pain to assemble. This B1B looks amazing.
I thought I heard in the long video not to use the trim buttons in flight. Did I hear that correctly. If so, how to trim if it is rolling or climbing?
Hi Jeremy when using spektrum AS3x do you turn OFF the Controller board ? I notice your switch was On Thx again
nice info !! thnxs
Can you share that spectrum setup file?