SolidWorks: Worm Gear - Assembly - motion

SolidWorks: Worm Gear - assembly - motion
Worm gears are constructed of a worm and a gear (sometimes referred to as a worm wheel), with non-parallel, non-intersecting shafts oriented 90 degrees to each other. The worm is analogous to a screw with a V-type thread, and the gear is analogous to a spur gear. The worm is typically the driving component, with the worm’s thread advancing the teeth of the gear.
If you don’t know demands I use in this video, please watch my playlist: Solidworks Tutorial to know more information (nếu bạn không hiểu những lệnh mình sử dụng trong video này, mời bạn xem trong danh sách phát Solidworks Tutorial để tìm hiểu)
Solidworks tutorial
• SOLIDWORKS TUTORIAL
#solidworks #tutorial #gear
Subscribe my channel (please!):
/ @cadtutorialmax
Visit my website (thanks!):
Solidworks tutorial: bit.ly/2LjtMzI
Creo Parametric tutorial: bit.ly/2JFmC5T
My 3D CAD: bit.ly/2XEn1iN

[@mon.ngon.tu.nhien.2018]

những bài chia sẽ của bạn hay và bổ ích lắm

[@oadka]

Assembly starts at 18:40

[@sivaprasadbobbili1304]

Thank you...

[@D.pietertje]

mooi gedaan!

[@CADTUTORIALmax]

thank you very much!

[@diasakimbay1631]

how to define pitch of the worm gear in terms of parameters of spur gear?

[@nhwahyu]

can you explain more about how to define the size of worm gear based on if i want to use Outer diameter?

[@CADTUTORIALmax]

thank you for your comment!
outer diameter: d=m(z+2). m is module . z is teeth of gear

[@muhammadmuzamil3248]

@@CADTUTORIALmax Hi CAD Tutorial. Would you mind to give the value of module (m) and teeth of gear (z) based on this tutorial?

[@CADTUTORIALmax]

@@muhammadmuzamil3248 hello. thank you for watching my video. value of module (m) is 2 and teeth of gear (z) is 60. I hope my video is useful for you!

[@jilpatel7789]

how to add part 7 explain plz

[@wizardhunts8078]

Somewhere before 2:39 length of rectangle is 60, but after trimming the dimension is gone. Is that affecting the revolve extrude?

[@CADTUTORIALmax]

Thank you for watching, if you don't move the drawing, the size will not change, to make sure you have 60 parameters to the cut edge, if there is something wrong with the video, please forgive

[@jaredtan547]

how to calculate the angle in 12:54 ? my material diameter is 56mm

[@CADTUTORIALmax]

angle = 180/number of teeth

[@jaredtan547]

@@CADTUTORIALmax how can i know the triple circle diameter ? my worm gear is 56mm.
outer diameter: d=m(z+2). m is module . z is teeth of gear
outer diameter: 56=56(8+2). m is module . z is teeth of gear
so the first outside circle is 66mm , second is 61mm ,and the last one circle is 56mm ?