PIR activated Servo using Cutebot Expansion board

This video demonstrates the use of the PIR motion sensor connected to the input pin on the Elecfreaks Cuteboard expansion board to activated the servo motor to turn through a specific angle. In this set up the PIR Motion sensor from Keyestudio was used. (Any PIR motion sensor would work). The servo is a standard SG90 servo motor (3.3 to 5 V). The servo motor is connected to the servo pin on the expansion board.
**Hint
On start while true (loop), if the condition of the PIR sensor compared to a comparator (logic and if else loop) == 1 (motion detected, the servo motor shaft shall rotate an angle set to 180 C, else shall return to 0 degrees.
Related videos
• Microbit Projects : AI...