Amazing, mini cylinder with maxí power. In old units, 1 bar is 1kg/cm. If the cylinder has a diameter of 10cm = an area of 25 x pi =75 cm² we can make a pressing force of 75kg with each bar. I think the force to cut this steel profile should be min. 75t. This means 1000 bar. OK, the cylinder ist bigger than 100mm. But too much for pneumatic due to the diesel effect. You cannot make this fast, simple calculation "without taking your hands out of your pockets" with Newton, sqare inch and PSI ! Careful, this calculation leads to wrong results if you are on the moon:)))
Wie kann ich diese druckmaschine bestellen und wie viel kostet sie und wo wie sie hergestellt und wie lautet die telefonnummer des Unternehmens das sie herstellt???
Rất hay và bổ ích
saving cost of gas and electric,good cutter for small units .
Yes, it is.
Wow.It's very good.
Amazing, mini cylinder with maxí power. In old units, 1 bar is 1kg/cm. If the cylinder has a diameter of 10cm = an area of 25 x pi =75 cm² we can make a pressing force of 75kg with each bar. I think the force to cut this steel profile should be min. 75t. This means 1000 bar. OK, the cylinder ist bigger than 100mm. But too much for pneumatic due to the diesel effect. You cannot make this fast, simple calculation "without taking your hands out of your pockets" with Newton, sqare inch and PSI !
Careful, this calculation leads to wrong results if you are on the moon:)))
Wolfgang Ihde
Wolfgang Ihde Why would be the result wrong?
yeah, the 75kg because there is no air pressuer, but thats it.
Wie kann ich diese druckmaschine bestellen und wie viel kostet sie und wo wie sie hergestellt und wie lautet die telefonnummer des Unternehmens das sie herstellt???
How much pressure required for this purpose???
Was that filmed on a potato?!
And then you use a Chopsaw Dady to cut off the snapped of end, or file it flat all day long.
Ne kadar güçlü makine 👍
Does anybody else think that looks pneumatic
THE VANDAL both!
what is background music, do you know
That is pump running sound
That’s very cool but doesn’t seem practical. There are way more efficient ways to cut that beam.
UUUHHYY
ME DIO MIEDO.
PENSE QUE SE IBA A EXPLOTAR..
Lu Cho masssssss PUTTTTTT
Wao i am intrested to buy send me details
ha de costar lo que vale mi casa carajos
wow
very very slow just grap a torch or angle cutter way faster
What torch or angle have you ever used that would be faster? And the hardest part of it was lifting the piece.
?less than a minute you can cut that with WHAT?
jason maes lifting it isn't the hardest part. The cutting is hard
jason maes this takes more than 2 minutes they just forwarded the video, just check it when they zoom out the piston is already half way out.
@just for fun : this was not invented to be faster. It is invented for environments where open fire and sparks are too dangerous.
Aku orang indonesia
Using katana will be easier in just 5sec
What is a katana
🇯🇲👍
Nao
..esticazzzz
Tá com nada
It's stupid. Completely unpractical