Thank you for the great content. Are you using the autofocus from the control board on the machine, or using lightburn to autofocus? Thank you so much.
How is the engraving quality on the 150w? Looking at picking one up but what it seems the higher watt poor engraving. We are doing like 50/50 on engraving and cutting. This type of information is hard to come by.
I measured it the other day. With the bed as low as it goes measuring roughly from the focus point down to the knives there is about 9 inches. If you needed more than that you could remove the knives and go all the way down to the catch tray.
Thank you for that. I just ordered the 2440 pro. Can't wait and hope that the quality is as they advertise.
Nice! Were you able to apply my affiliate/discount code?
Thank you for the great content. Are you using the autofocus from the control board on the machine, or using lightburn to autofocus? Thank you so much.
I would be curious to see how much better that would look if you upgraded your air assist to compressor unless you already have for this video
Cut some sheet metal! that's what I'm excited for.
its a gimmic
I totally spaced on that. There was a pre-ordered discount that was applied. Not sure if they would have discounted more or would they have?
How is the engraving quality on the 150w? Looking at picking one up but what it seems the higher watt poor engraving. We are doing like 50/50 on engraving and cutting. This type of information is hard to come by.
Nice! I never thought about circles vs. squares in testing...excellent! Does the Polar have a red dot for framing?
Do you think the Pro 100 is better than the AF3555-130 130 watt
Are you running stock air or a compressor?
great information
Compressor air assist would help cut a whole lot better.
What are the settings in the remote?
Surprised you were able to use lightburn on this model. It wasn't a listed option for this unit on the OMTech website.
It has worked perfectly from day one. You just have to install the trocen specific drivers before using Lightburn.
Does this only work for Windows PC? Does it do Mac?
Great content
Shall I assume this is an early access product to you only?
I have a 4063 unit...this pro line is miles ahead of my 4063.
Yes, this has not been released yet but coming very soon.
Do you happen to know the max z height? Appears to be missing from the specs.
I measured it the other day. With the bed as low as it goes measuring roughly from the focus point down to the knives there is about 9 inches. If you needed more than that you could remove the knives and go all the way down to the catch tray.
What was the minimum settings? Because it is important and you never mention this why?
What settings are you talk about?
$13k machine
$5 microphone
Good video. Get a wearable mic! 😂🤣🤪
The fans are the problem
@@BeardedBuildsCoalways a smart a§§ in the bunch