Hello, how are you Professor, I have a simple question Why does a signal appear? Release trouble When connecting the selenoid to the cylinder As soon as I turn off the selenoid, the signal disappears. I hope you can find a solution for me
Arosol firpro same panel I installed but extinguish point 1 deiod is connected if I removed panel give trouble can you guide me . Because as per manufacturer deiod need to remove
Good Video
Hi Sir, in 2nd stage alarm only horn will activate then strobe light will not flash? Or on releasing time then it will flash? Thank you!
@@yeoj8358 horn will activate with strobe at 20bpm that is in counting mode..
@@engineersguidehelp Thank you Sir, Sir in our testing strobelight activate @ 33secs, is it normal Sir?
@@yeoj8358 by that time it would have discharged already ..connect it to nac 3 and nac 1 for inside
@@engineersguidehelp Yes Sir, hornstrobe connected in NAC 3, then bell in NAC 1
Hello, how are you
Professor, I have a simple question
Why does a signal appear?
Release trouble
When connecting the selenoid to the cylinder
As soon as I turn off the selenoid, the signal disappears. I hope you can find a solution for me
@@safaakadhim5040 which kind of solenoid are you using,mostly wiring is dependant on the type of solenoid
Arosol firpro same panel I installed but extinguish point 1 deiod is connected if I removed panel give trouble can you guide me . Because as per manufacturer deiod need to remove
no, diode has to be connected as the end of line unless you are using the jumper in the sequential actuator
Csn you share circuit diagram