Hello Sir, Have a good day. I have recently facing problem in a newly buying Siemens PS2(2wire, 4-20ma, 2 wire, without HART) smart positioner connect with my existing Single acting, air to open linear actuator(pneumatic control valve) having 20mm stroke when I am going to newly calibation. During commissioning this new positioner with existing control valve/actuator in initial condition its display shows P 85 and NOINI mode, at that time when if i press (+) and (-) button then the actuator totally doesn’t not move.only small clicking sound hearing inside the positioner and little air Release from actuating pressureline(Y1) of positioner , however pneumatic(4kg air pressure) and electrical(4ma , 24VDc) connection is there. Interesting is if i place old existing positioner there then it easily move the actuator after pressing (+) and (- ) key in NOINI mode. Is there any problem of lever setting or restrictor setting there.i don’t change any restrictor setting in this newly buying positioner during commissioning there.i am confused if there any setting required in restrictor at positioner during newly commissioning? Anybody here who can advice me kindly please to fix this problem.
Plz described the manual calibration
D1 and D2 value
Hello Sir,
Have a good day.
I have recently facing problem in a newly buying Siemens PS2(2wire, 4-20ma, 2 wire, without HART) smart positioner connect with my existing Single acting, air to open linear actuator(pneumatic control valve) having 20mm stroke when I am going to newly calibation.
During commissioning this new positioner with existing control valve/actuator in initial condition its display shows P 85 and NOINI mode, at
that time when if i press (+) and (-) button then the actuator
totally doesn’t not move.only small clicking sound hearing inside the positioner and little air Release from actuating pressureline(Y1) of positioner , however pneumatic(4kg air pressure) and electrical(4ma , 24VDc) connection
is there. Interesting is if i place old existing positioner there then it easily move the actuator after pressing (+) and (- ) key in NOINI mode. Is there any
problem of lever setting or restrictor setting there.i don’t change any
restrictor setting in this newly buying positioner during commissioning there.i
am confused if there any setting required in restrictor at positioner during
newly commissioning?
Anybody here who can advice me kindly please to fix this
problem.
They just whant mony , 😂😂😂 from you.
😂😂😂😂 garbage positioner that is using a variable resistor 😅😅 that get vanish in vibrations environment ..
Mockery for tru