These videos were a great help, I will say I was able to get the pins out without drilling them. I folded them in on themselves with a tiny punch, then took a small drill bit a played with it untill I was able to grab the pin and pull it out. One took 15-20minutes, one took 2minutes.
+donballe Lot's of cursing! Actually, after successfully doing one side, I saw where the hole was on the clutch and decided to drill from the back on the side I broke the bit in. I was extremely lucky and drilled it out bang on!
Should make me a secondary bearing puller ill buy it from you im in need of 1 get ahold of me through youtube we can communicate here im from the village in AK I aint got all the equipment you got
These videos were a great help, I will say I was able to get the pins out without drilling them. I folded them in on themselves with a tiny punch, then took a small drill bit a played with it untill I was able to grab the pin and pull it out. One took 15-20minutes, one took 2minutes.
Great Video Series. Very helpful.
how did you get the broken drillbits out?
+donballe Lot's of cursing! Actually, after successfully doing one side, I saw where the hole was on the clutch and decided to drill from the back on the side I broke the bit in. I was extremely lucky and drilled it out bang on!
thank you, i got mine out eventually. drill bit broke on one side, the other went just fine. .-)
A small tap and a little patience will get the roll pins out.
Yup id rather not use an impact wrench to
Should make me a secondary bearing puller ill buy it from you im in need of 1 get ahold of me through youtube we can communicate here im from the village in AK I aint got all the equipment you got