I have sz305 voltage mode - resistance = 9.8M ohm on red and black probe battery test mode - resistance = 500ohm on red and black probe battery test mode 12v-maximum to test up to 20v your video clip perfect to reviews thank you.
Appears there are large holes for a proper shunt wire to be soldered, but they tried to save money. Instead of this wire they put a 10 milliohm resistor between 10A input and common and put a note on the front of the unit maximum 10 seconds. However, no warming in the manual. Time to lubricate that selector wheel. It's so dry, and the spring arms really get driven down into the crests of the case. They will break prematurely without grease. With no white mark on the selector indicator, you don't know which way the wheel is turned at a glance, could result in wrong range. They also forgot to install the transistor receptacle. I will be very difficult to get the transistor wires to all three touch the PCB.
yes,no fuse ,in mA only have resistor for protection,and other is a PTC ,IT MUST BE BROKEN meter main IC if you wrong testing in current position. before i burned three of this type meter be careful.
проверка ёмкости до 20mF - шикарно. Спасибо за обзор и тесты. Успехов!
thx for watching.
Thanks for the very detailed test! Special thanks for disassembling and showing the internal contents!
thx for watching
Obrigado pelo teste completo senhor Wilson 😃
thx for watching❤
Hello Mr. Wilson, can you tell me if this ANENG SZ305 model reads in TRUE RMS?
@@luizmello7020 you must make caculate by Vmax X 0.707
or choice aneng 616.it true rms not use to any calculated.
I'm thinking about the low cost option SZ304...do you think I can trust ?
I have sz305
voltage mode - resistance = 9.8M ohm on red and black probe
battery test mode - resistance = 500ohm on red and black probe
battery test mode 12v-maximum to test up to 20v
your video clip perfect to reviews
thank you.
thx for watching sir.
Thanks, very good!
thx for watching.
Hi Wilson. Which one is better aneng 616 vs aneng 620 ?????
620A aneng is easy to buy the testing pen.and 616 is hard to buy the test pen .sir
Appears there are large holes for a proper shunt wire to be soldered, but they tried to save money. Instead of this wire they put a 10 milliohm resistor between 10A input and common and put a note on the front of the unit maximum 10 seconds. However, no warming in the manual.
Time to lubricate that selector wheel. It's so dry, and the spring arms really get driven down into the crests of the case. They will break prematurely without grease. With no white mark on the selector indicator, you don't know which way the wheel is turned at a glance, could result in wrong range.
They also forgot to install the transistor receptacle. I will be very difficult to get the transistor wires to all three touch the PCB.
it company mistake or save their money,make a low prices multimeter,😕
The circuit board is too sketchy
thx for watching,it aneng design circuit for an low prices meter.
This multimeter is no fuse
yes,no fuse ,in mA only have resistor for protection,and other is a PTC ,IT MUST BE BROKEN meter main IC if you wrong testing in current position. before i burned three of this type meter be careful.
Hi Wilson. Which one is better aneng 616 vs aneng 620 ?????
🙏