I'm surprised that the coping saw blade fit down the kerf left by the dozuki! I have to start mine in the middle of the gap between kerfs and sweep over, otherwise it scars up the cut.
I used to have to do the same thing, I had to buy the thinnest coping saw blades I could find and they're still too big really, but they get the job done 👍.
Your dovetails went together amazingly well. That many tails in a 11.24" board is a very tough challenge to get right. Hats off to you!!
Well done, part II as good as part one, about to watch part 3
I learned a lot as a beginner thanks.
That's awesome, thanks so much for letting me know!
I'm surprised that the coping saw blade fit down the kerf left by the dozuki! I have to start mine in the middle of the gap between kerfs and sweep over, otherwise it scars up the cut.
I used to have to do the same thing, I had to buy the thinnest coping saw blades I could find and they're still too big really, but they get the job done 👍.
May I ask , what's the angle for the opening door ??!