Thanks for the insight, will be useful for my project 👍 how did you refasten the lead and cable or do you use loc tite to keep from backing out? Thank you again
@@farmallerfa when you pulled out the shaft you had 2 bolts connected by a small cable with a lead seal holding the cap for the inside bearing to the shaft. Is that a tamper proof seal like they had on the original governors of the farmall H. Or is the cable to keep the 2 bolts from backing out.
Thanks for the insight, will be useful for my project 👍 how did you refasten the lead and cable or do you use loc tite to keep from backing out? Thank you again
I'm sorry, I don't follow about the "lead and cable".
@@farmallerfa when you pulled out the shaft you had 2 bolts connected by a small cable with a lead seal holding the cap for the inside bearing to the shaft. Is that a tamper proof seal like they had on the original governors of the farmall H. Or is the cable to keep the 2 bolts from backing out.
There was no lead seal. It was just wire run through the two bolt heads twisted after tightening.