Diy simple and easy metal detector | diy metal detector using lm386

แชร์
ฝัง
  • เผยแพร่เมื่อ 11 พ.ย. 2024

ความคิดเห็น • 7

  • @hodhod.data.analysis
    @hodhod.data.analysis 4 หลายเดือนก่อน

    Thanks for your valuable project. I have rebuilt the circuit but it would not go with the BC945 maybe because ive damaged it with heat from soldering . I replaced the BC945 with a BC547 transistor and it worked with constant loud buzzer. The coil was sensitive at 40 cm but the buzzer sound variation is difficult to discern. I can tell the buzzer shows some variability but it needs a careful ear to distinguish. I dont know if anything can be added to make the sound variability easier to distinguish. Note the circuit is exactly the same to yours but i used an NPN BC 547 transistor instead of the bc945 transistor with 0.4 mm copper wire 52 turns and volts battery . I tried adding B10k potentiometer to control the buzzer volume, but it was not very helpful.
    Any advice?
    Many thanks to your useful videos.

    • @Electorr
      @Electorr  4 หลายเดือนก่อน +1

      Hi brother
      Lower the voltage until noise reduction. Mine worked in 6 - 7 volt. And your coil is ok, I hope it works for you.

    • @hodhod.data.analysis
      @hodhod.data.analysis 4 หลายเดือนก่อน

      @@Electorr Thank you so much.

  • @حمیدشیاسب
    @حمیدشیاسب 4 หลายเดือนก่อน

    عالیه❤

    • @Electorr
      @Electorr  4 หลายเดือนก่อน

      سپاس

  • @naganna6988
    @naganna6988 4 หลายเดือนก่อน

    Will this circuit work, i tried many circuits available on internet. They are not working and this is my topic for mini project. Will it work? Please reply Sir 🙏

    • @Electorr
      @Electorr  4 หลายเดือนก่อน +2

      All my projects work, but you should build them exactly what I built. Goodluck