Grateful, it explains in detail the hot air gun temperature and wind speed required for welding ASIC chips. It is a knowledge point worth collecting for novices.
Glad it was helpful to you. The solder paste we use is *_ NC-559-ASM flux paste_* , product details: www.zeusbtc.com/ASIC-Miner-Repair/Parts-Tools-Details.asp?ID=2277
Referring to the temperature and wind speed in the video, it will take about 7 seconds. When the solder paste on the pin starts to shine, it means that the solder paste has melted.
Yes. You can go to this website for more information: _course.zeusbtc.com_ Or contact us via: Sales Whatsapp: _ +8619115061759_ Technical Whatsapp: _+8619123969124_
Thanks for the reminder, we will pay attention to this detail in the future. Fortunately, the ground value of the tested chip shows that the connection is normal.
Oh, într-adevăr puțin, vom fi atenți la acest detaliu data viitoare, mulțumesc pentru memento. Din fericire, nu există nicio problemă cu conexiunea cipului după testare.
Helpful technical videos, full of tips and tricks 👍
Glad it was helpful!
Grateful, it explains in detail the hot air gun temperature and wind speed required for welding ASIC chips. It is a knowledge point worth collecting for novices.
Glad it helped you
Everything is explained in detail, I will try to use this method for asic chip soldering practice.
Yes. Good luck to you.
I am new to asic miner repair, this soldering guide helps a lot, thanks. More, what is the solder paste used？
Glad it was helpful to you. The solder paste we use is *_ NC-559-ASM flux paste_* , product details: www.zeusbtc.com/ASIC-Miner-Repair/Parts-Tools-Details.asp?ID=2277
Tin the new ASIC chip, replenish the pads, place the chip on the pads, add flux, heat and melt the solder paste, practice more.
Thanks. We will make corrections and improvements.
Perfect work! how long does it take to melt the tin on the chip pins?
Referring to the temperature and wind speed in the video, it will take about 7 seconds. When the solder paste on the pin starts to shine, it means that the solder paste has melted.
How to ensure that the surrounding original parts will not be "lost" during soldering? Thanks in advance.
Your heat gun needs to select the appropriate wind speed and temperature
I have an eye for maintenance courses. Is there any course for Antminer S19XP?
Yes. You can go to this website for more information: _course.zeusbtc.com_
Or contact us via:
Sales Whatsapp: _ +8619115061759_
Technical Whatsapp: _+8619123969124_
@@ZEUSMINING Thx！
This is one way. Certainly not the most perfect method, slightly flawed, but the inspection repair is correct.
Yes, there are many ways. We will also improve in the future
How do you no the ships is damaged
If you mean the chip, we have measured it before.
Next time add some less flux! Still you did a good job👍
Ok ,thanks!
Your text-to-speech blows !
Thanks for your suggestions, we will continue to improve.
Too much solder, and you bridged the board and chip...
Thanks for the reminder, we will pay attention to this detail in the future. Fortunately, the ground value of the tested chip shows that the connection is normal.
????? ai lipit chip-ul strâmb!!!!
Oh, într-adevăr puțin, vom fi atenți la acest detaliu data viitoare, mulțumesc pentru memento. Din fericire, nu există nicio problemă cu conexiunea cipului după testare.