Ken PIccininni it worked great for me! Both sides started getting warm at the same time and fired up very well. Def should give it a try. Thanks for watching
My bike started but then stalled when I removed the vacuum lines and wouldn't start again But started when I plugged them back in? My carbs also look slightly different but I have a 88 virago 750.
I have a 1984 Yamaha virago I was wanting to know if I could put two separate carburators on the bike like two cheap 350cc rateded carbs one on each cylinder set up the same way.
I’d definitely would recommend putting original parts like a Hitachi Carb or Mikuni carb. If you really want to go All out, I’d get a VM 38 flat sides. I honestly don’t know if 350cc carbs would work. They’re carbs so it maybe will work? Just gotta have the manifolds and intake seated properly and make sure you have your accelerating wire getting to both carbs.
Manual suggests the center screw is for 3-4000 rpm sync noooo
But will try this next time
Ken PIccininni it worked great for me! Both sides started getting warm at the same time and fired up very well. Def should give it a try. Thanks for watching
Hi, Lui! Would you like to provide a link to the carb sync gauge kit you used?
P1 Tools Motorcycle Vacuum Carburetor Synchronizer Carb Sync Gauge 2 Cylinder a.co/d/fASPQd6 I believe it’s these
@@lui1760 thanks, Lui!
thank you for the video!!
My bike started but then stalled when I removed the vacuum lines and wouldn't start again But started when I plugged them back in? My carbs also look slightly different but I have a 88 virago 750.
You might have a set of mukini carbs. The ones here are Hitachi. Those little plugs have to be capped off by a piece of rubber 😀
Thanks for the video bro im doing this on a vulcan 500 tomorrow. Tia
riggs_ nation no problem man! Here to help others! Good luck! 🍀👍
5. match both arrows by adjusting screw between carbs. Which screw is it in the video? Hitachi carburettors
Hey Lui, Did you have to do that after the dynojet setup?
Anytime you open the carbs, you want to double check by doing this procedure. 😎
I did mine because I had to mess with my fuel etc
You have not shown which screw you synchronize the carburetors, besides, the movie is great, readability is full.
Wow! I didn’t even notice that. That’s totally my bad. But if you do need to know what screw, it’s right between the carbs. It’s a gold Phillip screw.
@@lui1760 Thank you
I have a 1984 Yamaha virago I was wanting to know if I could put two separate carburators on the bike like two cheap 350cc rateded carbs one on each cylinder set up the same way.
How many ccs is your bike?
700
I’d definitely would recommend putting original parts like a Hitachi Carb or Mikuni carb. If you really want to go All out, I’d get a VM 38 flat sides. I honestly don’t know if 350cc carbs would work. They’re carbs so it maybe will work? Just gotta have the manifolds and intake seated properly and make sure you have your accelerating wire getting to both carbs.