one way to avoid overloading the amp, you can use slightly longer wires to the speakers than intended, this will slightly increase the resistance of the circuit and reduce the load on the amp, but watch the temperature of the amp so that it does not overheat and has good air access, because these multi-channel amplifiers suffer a lot directly from overheating, all solders shrink crack and electrolytic capacitors dry out.
How to get a strong signal with the antenna, only the input and the wire I think it's not enough. And please, do you have a video for setting the receiver, like, radio stations, etc.
If you live in a place where good quality FM radio station signals are available, then a normal, non-active, antenna is completely sufficient, provided that this receiver is without defects and well tuned (I mean the part of the radio receiver inside the receiver). If you live very far from cities and broadcasting stations, then you can use both indoor and outdoor antennas, with an active amplifier of the FM signal. But the receiver of this model often suffers from age problems, and this directly affects radio reception. The main problems are with the electrolytic capacitors, on the power supply board, as well as with micro cracks in the solders, on all motherboards, including the receiver board. Years and time take their toll, and in order to continue using it to its full potential, full maintenance and restoration may also be necessary. During the last six months, I have restored several devices of this model, all of them have the same problems - capacitors, soldering, tuning. No, I don't have a video on how to save radio stations, because it is relatively simple, and all these devices have long since been repaired and returned to their owners, and they are happy. 🎶🎶
Nice receiver. Excellent track!
Great amplituner
good receiver
Can it drive 6 ohm speakers?
one way to avoid overloading the amp, you can use slightly longer wires to the speakers than intended, this will slightly increase the resistance of the circuit and reduce the load on the amp, but watch the temperature of the amp so that it does not overheat and has good air access, because these multi-channel amplifiers suffer a lot directly from overheating, all solders shrink crack and electrolytic capacitors dry out.
How to get a strong signal with the antenna, only the input and the wire I think it's not enough. And please, do you have a video for setting the receiver, like, radio stations, etc.
If you live in a place where good quality FM radio station signals are available, then a normal, non-active, antenna is completely sufficient, provided that this receiver is without defects and well tuned (I mean the part of the radio receiver inside the receiver). If you live very far from cities and broadcasting stations, then you can use both indoor and outdoor antennas, with an active amplifier of the FM signal. But the receiver of this model often suffers from age problems, and this directly affects radio reception. The main problems are with the electrolytic capacitors, on the power supply board, as well as with micro cracks in the solders, on all motherboards, including the receiver board. Years and time take their toll, and in order to continue using it to its full potential, full maintenance and restoration may also be necessary. During the last six months, I have restored several devices of this model, all of them have the same problems - capacitors, soldering, tuning. No, I don't have a video on how to save radio stations, because it is relatively simple, and all these devices have long since been repaired and returned to their owners, and they are happy. 🎶🎶
Where are you from ? I want to repair my AVR
Latvia, Riga