A couple people have broken some of the copper windings without heating it up, so if in doubt put some heat on it before trying to break it apart to loosen the epoxy up
Thanks for posting this. I know you replace the bearings with ceramic ones but whats the purpose of taking the last part off? You gonna pot that with epoxy or something?
@@jessewagnon1178 yeah your motor parameters don't work either. Bummer. MY 75100 Pro ESC I think can't detect the motor parameters properly in VESC Tool.
Jesse thanks for your video. I was wondering how to do this. When it comes to the replacing the wires. Is it just a case of de soldering and resoldering the new wires. There is nothing too special about it? Also, when it comes to waterproofing did you just use some epoxy on the new wires where it solders to the stator ?
A couple people have broken some of the copper windings without heating it up, so if in doubt put some heat on it before trying to break it apart to loosen the epoxy up
Thanks for posting this. I know you replace the bearings with ceramic ones but whats the purpose of taking the last part off? You gonna pot that with epoxy or something?
My VESC won’t detect correct motor parameters for these 6384s. Would you mind replying with your parameters so I can manually input them. Thank You!
I honestly don’t remember. Did you watch my video on the VESC setup?
th-cam.com/video/FxBS00QykyE/w-d-xo.htmlsi=YbFg87c2MIKbl3eF
@@jessewagnon1178 yeah your motor parameters don't work either. Bummer. MY 75100 Pro ESC I think can't detect the motor parameters properly in VESC Tool.
Did you run the motor detection wizard?
@@jessewagnon1178 yes, but it gives me terrible numbers that are clearly not right and the motor just whines after.
To replace the wires. They only come with 16awg. I replace with 12awg.
Jesse thanks for your video. I was wondering how to do this. When it comes to the replacing the wires. Is it just a case of de soldering and resoldering the new wires. There is nothing too special about it? Also, when it comes to waterproofing did you just use some epoxy on the new wires where it solders to the stator ?
Nothing special at all. I’m gonna make a video for that hopefully today. To waterproof I just soak in corrosion x.
@@jessewagnon1178 thank you.
Wire replacement.
th-cam.com/video/F6SWwLVkyr8/w-d-xo.htmlsi=apkkVCuSpeDV41sl
Thank you for the video !