Okuma LS Adventures Part 8: 4 Jaw chuck cleanup

[@mopedmarathon]

Clearance is clearance. Well said sir. Keep up the good work.

[@matthewmoilanen787]

Bart u really do an outstanding job on your projects!

[@bartharkemametalworks2299]

Thanks!

[@mudnducs]

Nice job Paul!!

[@anmafab]

Nice to have your back, Bart!

[@bartharkemametalworks2299]

Thanks, still there. I'm a little bit more active on Instagram these days but will keep sharing on YT for some bigger projects.

[@peem1244]

Hi Bart, hope you are keeping well. Super cleanup of your jaw makes it look nearly new, and ready for another long life. Thanks for sharing. Stay safe and keep up the good work.

[@bartharkemametalworks2299]

Thanks Pedro. And I'm doing very well.

[@a.bakker64]

Leuke video Bart. Had je al een tijdje gemist hier op TH-cam. 👍🏻

[@MattysWorkshop]

Gday Bart, looks like a brand new chuck now, excellent job mate and thanks for sharing, cheers

[@bartharkemametalworks2299]

Thanks Matty, Cheers!

[@LittleAussieRockets]

Aussie Aussie Aussie.

[@glennstasse5698]

From junk to very usable. Really nice work! As usual….

[@bartharkemametalworks2299]

Thanks!

[@fritsvanderplas3014]

Mooi en duidelijke video
Ga zo door man !!!

[@bartharkemametalworks2299]

Bedankt!

[@jpsimon206]

At least it will be very easy to swap chucks. Just two tiny shims, and you can crank it right off with the cross slide!

[@bartharkemametalworks2299]

Yes it is. Fun fact is that his chuck is a lot lighter than the Forkhardt but almost 100mm bigger. Just a very simple cast iron design.

[@benalter7316]

finally !! nice work thnx

[@bartharkemametalworks2299]

Thanks Ben!

[@yvesdesrosiers2396]

Hello Bart! How is the new father doing? Hope everyone is healthy. Stay safe. Cheers

[@bartharkemametalworks2299]

Yes doing very good 👍👍

[@topduk]

Nice, but how did you clean up the back where it mates with the lathe?

[@bartharkemametalworks2299]

Thanks. Most of the mounting is done on the taper. The back face was not too bad. I took of a few little high points with a flatstone.

[@greasemonkeypol]

sandvick is a very bad quality recycled insert dont use it.. for cast iron-steel you will need an insert without burr relief