🌞REFINED RINGER GENERATOR BOARDS & MORE EFFICIENCY BREAKTHROUGHS PLUS STUNNING WIRELESS POWER🌞
ฝัง
- เผยแพร่เมื่อ 20 ก.ค. 2024
- Greetings Everybody, in this video I demonstrate the new cleaned up & refined negative resistant generator boards that can rapidly recharge capacitors & batteries via the high frequency Undeniable negative resistance effect from our special tesla coil wound per patent 336,961 this system excels at the rapid recharging effect of batteries that can then be used to run a 120/240vac inverter for a time & the resonant power output is now equal to the power input while still maintaining mind bending wireless power effects & phenomenon when the system is Earth grounded.
The theory behind how the system operates is as follows & based off of concepts & theories from Don Smith & Eric Dollard.
First we created a super joule ringer 3.0 circuit first invented by lasersaber/laser hacker but what we do differently is we don't use that high frequency power output directly but instead we send that power into a Negative resistant RLC circuit/network composed of the proper valued CARBON FILM resistors & capacitors. (10K 15 Watt Carbon Film Resistor & a 2nF Ceramic Capacitor) once near perfect resonance & Negative resistance is achieved within this circuit we then earth ground it for even more non linear effects. We next then wound a resonant tesla coil per patent number 336,961 over this negative resistant RLC circuit with the theory & hope of being able to decouple cause from effect along with churning up excess power from the Aether & achieve a negative resistant super charge effect on our output & this output can be enhanced even further with the addition of a 0.22uF capacitor on the right hot leg to center tap of our yellow 336,961 tesla coil.
contacts:
mtechindustries2022@gmail.com
mtechindustriesshop2022@gmail.com
full ringer construction disclosure video link
• 🌟FULL RINGER CONSTRUCT...
want to buy a ringer or check us out/support us or just browse our vast free archives of ancient electrical engineering knowledge that's listed for free on our patreon? Any support helps in achieving our goal of becoming a small commercial electrical research company that pushes the bounds of what's possible with efficiency & sells exotic generators as well as providing full schematics & being open source because as far as it stands most electrical research isn't done anymore on the commercial level & if it is the results of the work are kept heavily supressed.
www.patreon.com/MTECHINDUSTRI...
links to other people doing good work
1. • TESLA PATENT + MY CIRC...
2. • The Ringer in Small St...
3. • INVENTOR3 OPEN-SOURCIN...
4. • it is wake up time
5. • 🤯 FREE ENERGY hidden &...
![[LIVE] : ONE ลุมพินี 71 วันนี้!! คู่เอก "ทรงชัยน้อย vs รักษ์"](http://i.ytimg.com/vi/_AGPnq2p6Js/mqdefault.jpg)
If this little circuit is able to maintain and recharge those batteries one could only wonder what Tesla was able to do in his lab. Thank you for the inspiration.
That AV Plug version 2 is AWESOME man, AWESOME, it is sooo shocking and so bright. I am barely waiting for my rods. Thanks for the email reply and pictures of the tracking information. I just got 2 6 amp/h LiPo4 batteries and I will replicate your work to the teeth and hopefully people will see how impressive this actually is.
.
Good work man.
.
@@FaustoGomes appreciate the support :)
Really nice work Mal! Did you remove the cold cathode ?
@MrDrStew Yes i found the system has become more simplified & performs better with just the correct value LCR network & Negative Resistance can still be achieved :)
@@MTECHINDUSTRIES2022 that's awesome, no more burning wood :P
Have you tried multiple resonant receiver coils? Essentially the same as what you were holding and taping into the radiant energy of the transmitter coil, but when holding it your body would be adding grounding or maybe capacitance.
I believe you could have many receiver resonant coils tapping into the radiant energy from the one transmitter coil. With each new resonant receiver coil you add to the circuit it wont draw anymore power from the battery, though frequency would need to be tuned again.
But you should then see sympathetic resonance where radiant energy is passed back to the transmitter (so even less power needed from the battery) and you can run loads from each receiver coil.
You know, I'm just thinking of ways to better, harness wireless power from this system. Suppose you try to recharge two batteries, having two systems and the load is switched between the two batteries, one charges say for 45sec whereas the other powers the load, and vice versa. If the current draw for the ringer is 100mA then in total we are using about 3W to power our load
Lovely!
What is the formula for calculating the required resistance for the -RLC circuit?
@JenkoRun i always used the correct value carbon film resistor that brings my power draw in the circuit to bare minimum then i add a capacitors in parallel with the resistor while simultaneously having the wireless output power going into a battery while my oscilliscope is hooked up & I'm looking for the waveforms that start small & grow big over time. It's not so much a formula per say but an observed effect that's sought after :)
@@MTECHINDUSTRIES2022 In that case we should to narrow down what the formula that governs the effect is through observation, if we can determine the formula it'll save a lot of guess work and bring more insight into underlining principles involved.
@@JenkoRun i can probably work it out & provide it within a week along with advanced measurements from all coils & components
Nice. Would you mind demonstrating the rapid recharge effect again, but this time while the voltmeter is increasing, disconnect the ringer charger and leave only the voltmeter measuring the battery by itself. This will prove that the voltage increase is not due to internal battery chemistry equilibrium. Thanks.
If this is done properly like don smith has said in many of his videos u would hav more power than u need
Hello, how many watts is the input, and the estimated output?
Awsome work, Mal! Do you know how many 2.2V LiFO4 and 2.7V capacitor cells are in the hybrid battery pack?
@badboypaulpark yeah it's a 14vdc 100F capacitor in parallel with a 13.8vdc 5ah lifepo4 battery with a built in battery management system up to 200vdc input
Ahh the Patreon, this is it. You need money
@@action4free369 i list all my exact schematics for free both on my patreon & youtube channel & don't all companies need money to operate?
@@MTECHINDUSTRIES2022 you are companies?
you don't use halogen bulb nomore?
@@Efest-777 i test all bulb types :)
@@MTECHINDUSTRIES2022 I mean cold cathode?
Look up Magnetic Moebius Tripole
☑️🌟
Sent you an email as you asked, regarding my order from 5 months ago which payment has already been made. and our conversation. thanks.
You have to pay first
@@action4free369 already paid
Already paid
@@Waveit5 sad
Got cheated
How is the auto tuning coming? Do you still need to manually dial this in?
I see that when you put in the wireless power receiver in that loop of wire it lights up. What if you purposefully made multiple loops like that in the primary circuit and then plug in multiple receiver and feed that extra power into the system to further boost efficiency? Maybe you could use that as your primary recharge source instead of having to turn it off to recharge it. Not sure if that would mess with the tuning though.
Just a few random thoughts, great work!
@shadowkiller123 appreciate the support & input & the auto tuning is nearly perfected & multiple correctly sized loops definitely seem like a good idea to try along with the wireless power collection from them. When everything's in resonance the wireless power effects are a phenomenal bonus with 0 input draw to the system :)
@@MTECHINDUSTRIES2022 so you're essentially saying that this thing can generate power out of nothing?
@computerkiller1494 it harvests excess power from negative resistance & the ambient environment & all generators are just different archforms for power manifestation. One could argue the newer clear solar pannels on the market generate power from nothing because as the light passes through them the light isn't converted to electricity but instead stimulates them into activation of the manifestation of energy :)
Subscribe ❤and i really appreciate your work Sir.
Scammer!
@@janno288 build it yourself for testing. All schematics provided completely for free & what research have you contributed to our corrupt dying planet that's on the brink of collapse?