How to Replace Rear Strut & Spring Assemblies 1992-1996 Toyota Camry

Buy Now!
New Strut & Spring Assembly from 1AAuto.com trq.video/ib-1...
This video shows you how to install new rear strut & spring assemblies from TRQ on your 1992-1996 Toyota Camry. TRQ Struts are made to fit your vehicle exactly, just like the original part. Struts can wear out as early as 50,000 miles. You should inspect them regularly for leaks or wear. Save time, money, and hassle by replacing an entire strut assembly.
Estimated installation time for a professional technician is approximately: 3 hours 6 minutes
This repair was done on a 1995 Toyota Camry LE 2.2L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
1992 Toyota Camry
1993 Toyota Camry
1994 Toyota Camry
1995 Toyota Camry
1996 Toyota Camry
Tools you will need:
• Phillips Head Screwdriver trq.video/obML...
• Pry Bar trq.video/oacI...
• 19mm Wrench trq.video/oaip...
• 12mm Socket trq.video/ociv...
• 15mm Socket trq.video/ociv...
• 19mm Socket
• 21mm Socket
• Torque Wrench trq.video/obk9...
• Gloves trq.video/oboP...
• Marker / Writing Utensil
• Safety Glasses
• Floor Jack trq.video/oaFi...
• Jack Stands trq.video/oarD...
Subscribe: / @trq
Check out our playlist:
Toyota Camry 1992-1996: • Toyota Camry 1992-1996
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@esepinchearod4558]

By original Hardware you're talking about for the knuckle to strut bolts correct? Tourqe to 145 ft-Ib unless using new bolts and nuts right? Just wanna make sure that's what I heard

[@martysmith6849]

When you use a pneumatic impact and crank bolts or nuts down and then torque to spec but the torque wrench immediately indicates to stop, you have probably overtorqued the sh*t out of the bolt/nut 😂