This is a great video - thank you. For years, I have taken power supplies an attempted to use them as a bench power supply. I never connected anything to anything other than the 12 volt. Each and every time, sometimes sooner than later, the power supply would just shut off. I would have to disconnect the power to the the power supply, wait a while and reconnect for them to reset. But, as always, they would shut off. So, I did not see/hear any mention of this problem with your set up here. PLEASE tell me how you got around this issue?
Great work.
This is a great video - thank you. For years, I have taken power supplies an attempted to use them as a bench power supply. I never connected anything to anything other than the 12 volt. Each and every time, sometimes sooner than later, the power supply would just shut off. I would have to disconnect the power to the the power supply, wait a while and reconnect for them to reset. But, as always, they would shut off.
So, I did not see/hear any mention of this problem with your set up here. PLEASE tell me how you got around this issue?
Really cool they have come out with quite a few new boards, I like yours but didn’t see it on Amazon, found close, do I ever need a 3d printer
The breakout boars should have been installed within the case and run wires to usb panel mount for a cleaner look
What was the pc psu that you used ?
where did you get that break out card?
I found all mine on eBay, TEMU and Aliexpress.