Adding backlight to cheap multimeter | Modifying cheap multimeter | Ut Go

In this video we will add backlight to the display of multimeter.
Component Link:
Multimeter : amzn.to/3IRSAw0
5 mm Green LED : amzn.to/3Xwy3Rv
Soldering Iron : amzn.to/3Xyswdm
Please share your modification ideas and thoughts regarding this video in the comment section.
In next video we will modify it further, so stay tuned.
Thanks for watching..
Like | Share | Subscribe
Royalty Free Music from Bensound

[@bravelionheart6572]

Simple, straight, and to the point; purposeful.

[@UtGoTech]

Thanks

[@talipgunes7022]

We may add a switch to turn it off when not needed. Also some SMD LEDs can be used just behind the screen and it may look much natural. Good content, keep it up sir.

[@UtGoTech]

Thanks 👍

[@surenderanm1863]

Good

[@UtGoTech]

Thanks

[@lifeai1889]

I did the exact same before watching this video(adding fuse to low current range and backlight)
The led drains the battery really fast so I added a switch in series so u can disable it if not needed
And the ohm,voltage,diode range is still not protected hope u can make a video about how to add ptc thirmister and metal oxide verraster for over voltage protection
And I have the even cheaper version which comes with absolutely no buzzer can u tell me where to connect one? Thanks

[@UtGoTech]

I will try to make one in future

[@kitecattestecke2303]

Does it glow led in all modes?

[@UtGoTech]

Yes, LED glows in all modes.

[@rayyan10011]

very fast friend the video

[@rayyan10011]

can u make it slow

[@rayyan10011]

i have same that multimeter

[@UtGoTech]

Ok i will try