I would like to know more about the bar chain oil feed. Mine is pouring bar chain oil out of it and I know it's missing something but when I look up the parts it's showing stuff for the 034 super and 036 and mine is set up different then those are I have the 034 model and from what I have seen it's the 1125 so I'm guessing it like a conversion when they went front the 034 to the 034AV
@@JandSChainsaw well the metal cover that goes over the stuff doesn't stay in with a screw like it shows on the others the oil is coming from a line up top above the studs. When I looked up the parts I found this part 0000 974 1200 Notched Pin 2 6x8 I don't understand how it's suppose to sat in there though
@@JandSChainsaw I'm waiting on parts too..jon bob and me built a farmertec 372..a very strong one and the piston failed and wrecked half the case and the crank..but boy did it run good for 4 tanks of fuel🤣👍🏻🤘🏻🪓
Thank you very much for the video. I am rebuilding a 034 and I look forward to your other videos. Hello From, New Hampshire!
I would like to know more about the bar chain oil feed. Mine is pouring bar chain oil out of it and I know it's missing something but when I look up the parts it's showing stuff for the 034 super and 036 and mine is set up different then those are I have the 034 model and from what I have seen it's the 1125 so I'm guessing it like a conversion when they went front the 034 to the 034AV
Should be th3 same I'd say 5he iul feed l8ne in the oil tank is leak8ng or missing it sets at the lower right corner under the oil pump
@@JandSChainsaw well the metal cover that goes over the stuff doesn't stay in with a screw like it shows on the others the oil is coming from a line up top above the studs. When I looked up the parts I found this part 0000 974 1200 Notched Pin 2 6x8 I don't understand how it's suppose to sat in there though
She will be a runner when u get done ..she's cruddy now but not for long..can't wait to see her run in all her glory...👍🏻🤘🏻🪓
I've got the stuff here to redo the bottom end..waiting on the meteor piston now..
@@JandSChainsaw I'm waiting on parts too..jon bob and me built a farmertec 372..a very strong one and the piston failed and wrecked half the case and the crank..but boy did it run good for 4 tanks of fuel🤣👍🏻🤘🏻🪓
@@Aaron_A_Lynch I have a big bore and pop up coming for mine hope it holds up lol
@@JandSChainsaw we used a cheap 272 piston .. using a meteor 272 piston on round 2.. lol 👍🏻🤘🏻🪓
❤❤
She sounds a little tired, I bet you wake it up!!👍👍👍👍🇺🇸🇺🇸🇺🇸🇺🇸🙏🙏🙏🙏
Would've be nice to see how you got that rear handle off
Just watch any of my stihl teardown videos most stihls come apart the same
@@JandSChainsaw thanks.
my old 034 second hand ,was very dirty under the handle i couldn't believe it
It sounded like it had a sump full of marbles.
Lol both bearings were shot as well as the wrist pin bearing..